1000+ Heat & Mass Transfer Multiple Choice Question Answer [Solved]

1. The time constant of a thermocouple is
A. The time taken to attain the final temperature to be measured
B. The time taken to attain 50% of the value of initial temperature difference
C. The time taken to attain 63.2% of the value of initial temperature difference
D. Determined by the time taken to reach 100°C from 0°C
Answer : C

2. The ratio of the thickness of thermal boundary layer to the thickness of hydrodynamic boundary layer is equal to (Prandtl number) n, where n is equal to
A. -1/3
B. -2/3
C. 1
D. -1
Answer : A

3. Thermal diffusivity of a substance is
A. Directly proportional to thermal conductivity
B. Inversely proportional to density of substance
C. Inversely proportional to specific heat
D. All of the above
Answer : D

4. Thermal conductivity of non-metallic amorphous solids with decrease in temperature
A. Increases
B. Decreases
C. Remain constant
D. May increase or decrease depending on temperature
Answer : B

5. The total radiation from a black body per second per unit area is ________ fourth power of the absolute temperature. This statement is known as Stefan Boltzmann law.
A. Equal to
B. Directly proportional to
C. Inversely proportional to
D. None of these
Answer : B

6. When absorptivity (?) = 1, reflectivity (?) = 0 and transmissivity (?) = 0, then the body is said to be a
A. Black body
B. Grey body
C. Opaque body
D. White body
Answer : A

7. Thermal conductivity of glass wool varies from sample to sample because of variation in
A. Composition
B. Density
C. Porosity
D. All of the above
Answer : D

8. Which of the following statement is wrong?
A. The heat transfer in liquid and gases takes place according to convection.
B. The amount of heat flow through a body is dependent upon the material of the body.
C. The thermal conductivity of solid metals increases with rise in temperature
D. Logarithmic mean temperature difference is not equal to the arithmetic mean temperature difference.
Answer : C

9. According to Stefan Boltzmann law, ideal radiators emit radiant energy at a rate proportional to
A. Absolute temperature
B. Square of temperature
C. Fourth power of absolute temperature
D. Fourth power of temperature
Answer : C

10. According to Prevost theory of heat exchange
A. It is impossible to transfer heat from low temperature source to t high temperature source
B. Heat transfer by radiation requires no medium
C. All bodies above absolute zero emit radiation
D. Heat transfer in most of the cases takes place by combination of conduction, convection and radiation
Answer : C

11. Fouling factor is used
A. In heat exchanger design as a safety factor
B. In case of Newtonian fluids
C. When a liquid exchanges heat with a gas
D. None of the above
Answer : A

12. In counter current flow heat exchanger, the logarithmic temperature difference between the fluids is ________ as compared to parallel flow heat exchanger.
A. Same
B. Less
C. Greater
D. None of these
Answer : C

13. Thermal diffusivity is a
A. Function of temperature
B. Physical property of a substance
C. Dimensionless parameter
D. All of these
Answer : B

14. The ratio of the energy absorbed by the body to total energy falling on it is called
A. Absorptive power
B. Emissive power
C. Absorptivity
D. Emissivity
Answer : A

15. The process of heat transfer from one particle of the fluid to another by the actual movement of the fluid particles due to difference of density caused by temperature of the particle is known as
A. Conduction
B. Free convection
C. Forced convection
D. Radiation
Answer : B

16. Heat flows from one body to other when they have
A. Different heat contents
B. Different specific heat
C. Different atomic structure
D. Different temperatures
Answer : D

17. Unit of thermal conductivity in S.I. units is
A. J/m² sec
B. J/m °K sec
C. W/m °K
D. Option (B) and (C) above
Answer : D

18. The transfer of heat by molecular collision is smallest in
A. Solids
B. Liquids
C. Gases
D. None of these
Answer : C

19. Cork is a good insulator because it has
A. Free electrons
B. Atoms colliding frequency
C. Low density
D. Porous body
Answer : D

20. In convection heat transfer from hot flue gases to water tube, even though flow may be turbulent, a laminar flow region (boundary layer of film) exists close to the tube. The heat transfer through this film takes place by
A. Convection
B. Radiation
C. Conduction
D. Both convection and conduction
Answer : C

21. The heat of sun reaches to us according to
A. Conduction
B. Convection
C. Radiation
D. None of these
Answer : C

22. Fourier's law of heat conduction is valid for
A. One dimensional cases only
B. Two dimensional cases only
C. Three dimensional cases only
D. Regular surfaces having non-uniform temperature gradients
Answer : A

23. The total emissivity power is .defined as the total amount of radiation emitted by a black body per unit
A. Temperature
B. Thickness
C. Area
D. Time
Answer : D

24. A grey body is one whose absorptivity
A. Varies with temperature
B. Varies with the wave length of incident ray
C. Varies with both
D. Does not vary with temperature and wave length of the incident ray
Answer : D

25. Depending on the radiating properties, a body will be black when
A. P = 0, x = 0 and a = 1
B. P= 1, T = 0 and a = 0
C. P = 0, x = 1 and a = 0
D. X = 0, a + p = 0 Where a = absorptivity, p = reflectivity, X = transmissivity.
Answer : A

26. In regenerator type heat exchanger, heat transfer takes place by
A. Direct mixing of hot and cold fluids
B. A complete separation between hot and cold fluids
C. Flow of hot and cold fluids alternately over a surface
D. Generation of heat again and again
Answer : C

27. According to Dalton's law of partial pressures, (where pb = Barometric pressure, pa = Partial pressure of dry air, and pv = Partial pressure of water vapour)
A. Pb = pa - pv
B. Pb = pa + pv
C. Pb = pa × pv
D. Pb = pa/pv
Answer : B

28. Which of the following is a case of steady state heat transfer?
A. I.C. engine
B. Air preheaters
C. Heating of building in winter
D. None of the above
Answer : D

29. The heat transfer by conduction through a thick sphere is given by
A. Q = 2?kr₁ r₂ (T₁ - T₂)/ (r₂ - r₁)
B. Q = 4?kr₁ r₂ (T₁ - T₂)/ (r₂ - r₁)
C. Q = 6?kr₁ r₂ (T₁ - T₂)/ (r₂ - r₁)
D. Q = 8?kr₁ r₂ (T₁ - T₂)/ (r₂ - r₁)
Answer : B

30. The rate of energy emission from unit surface area through unit solid angle, along a normal to the surface, is known as
A. Emissivity
B. Transmissivity
C. Reflectivity
D. Intensity of radiation
Answer : D

31. Thermal diffusivity of a substance is given by (where h = Thermal diffusivity, ? = Density of substance, S = Specific heat, and k = Thermal conductivity)
A. h = k/ ?S
B. h = ?S/k
C. h = S/?k
D. h = k?/S
Answer : A

32. Unit of thermal diffusivity is
A. m²/hr
B. m²/hr °C
C. kcal/m² hr
D. kcal/m. hr °C
Answer : A

33. The amount of heat flow through a body by conduction is
A. Directly proportional to the surface area of the body
B. Directly proportional to the temperature difference on the two faces of the body
C. Dependent upon the material of the body
D. All of the above
Answer : D

34. If the temperature of a solid surface changes from 27°C to 627°C, then its emissive power changes in the ratio of
A. 6
B. 9
C. 27
D. 81
Answer : D

35. The insulation ability of an insulator with the presence of moisture would
A. Increase
B. Decrease
C. Remain unaffected
D. May increase/decrease depending on temperature and thickness of insulation
Answer : B

36. In counter flow heat exchangers
A. Both the fluids at inlet (of heat exchanger where hot fluid enters) are in their coldest state
B. Both the fluids at inlet are in their hottest state
C. Both the fluids at exit are in their hottest state
D. One fluid is in hottest state and other in coldest state at inlet
Answer : B

37. The heat transfer takes place according to
A. Zeroth law of thermodynamics
B. First law of thermodynamics
C. Second law of thermodynamics
D. Kirchhoff's law
Answer : C

38. Two plates spaced 150 mm apart are maintained at 1000°C and 70°C. The heat transfer will take place mainly by
A. Convection
B. Radiation
C. Forced convection
D. Free convection
Answer : B

39. Pick up the wrong case. Heat flowing from one side to other depends directly on
A. Face area
B. Time
C. Thickness
D. Temperature difference
Answer : C

40. The heat transfer by conduction through a thick cylinder (Q) is given by (where T? = Higher temperature, T? = Lower temperature, r? = Inside radius, r? = Outside radius, l = Length of cylinder, and k = Thermal conductivity)
A. Q = [2?lk (T? - T?)]/2.3 log (r?/r?)
B. Q = 2.3 log (r?/r?)/[2?lk (T? - T?)]
C. Q = [2? (T? - T?)]/2.3 lk log (r?/r?)
D. Q = = 2?lk/2.3 (T? - T?) log (r?/r?)
Answer : A

41. Depending on the radiating properties, a body will be opaque when
A. P = 0, x = 0 and a = 1
B. P=1, x = 0 and a = 0
C. P = 0, x = 1 and a = 0
D. X = 0, a + p = 1 Where a = absorptivity, p = reflectivity, X = transmissivity.
Answer : D

42. The unit of Stefan Boltzmann constant is
A. Watt/cm² °K
B. Watt/cm4 °K
C. Watt²/cm °K?
D. Watt/cm² °K?
Answer : D

43. The most commonly used method for the design of duct size is the
A. Velocity reduction method
B. Equal friction method
C. Static regains method
D. Dual or double method
Answer : C

44. Log mean temperature difference in case of counter flow compared to parallel flow will be
A. Same
B. More
C. Less
D. Depends on other factors
Answer : B

45. Radiation is the process of heat transfer in which heat flows from a ________, in a straight line, without affecting the intervening medium.
A. Cold body to hot body
B. Hot body to cold body
C. Smaller body to larger body
D. Larger body to smaller body
Answer : B

46. Thermal conductivity of air with rise in temperature
A. Increases
B. Decreases
C. Remain constant
D. May increase or decrease depending on temperature
Answer : A

47. Depending on the radiating properties, a body will be white when
A. P = 0, x = 0 and a = 1
B. P=1, T = 0 and a = 0
C. P = 0, x = 1 and a = 0
D. X = 0, a + p = 1 Where a = absorptivity, p = reflectivity, x = transmissivity
Answer : B

48. In heat transfer, conductance equals conductivity (kcal/hr/sq.m/ °C/cm) divided by
A. Hr (time)
B. Sq. m (area)
C. °C (temperature)
D. K.cal (heat)
Answer : D

49. The value of the wavelength for maximum emissive power is given by
A. Wien's law
B. Planck's law
C. Stefan's law
D. Fourier's law
Answer : A

50. The critical thickness of insulation for a sphere is
A. k/h?
B. 2k/h?
C. h?/k
D. h?/2k
Answer : B