Chemical Engineering Plant Economics 1000+ MCQ with answer for GMAT

1. Pick out the wrong statement.
A. Gross revenue is that total amount of capital received as a result of the sale of goods or service
B. Net revenue is the total profit remaining after deducting all costs excluding taxes
C. The ratio of immediately available cash to the total current liabilities is known as the cash ratio
D. Consolidated income statement based on a given time period indicates surplus capital and shows the relationship among total income, costs & profit over the time interval
Answer : B

2. Which of the following methods of depreciation calculations results in book values greater than those obtained with straight line method?
A. Multiple straight line method
B. Sinking fund method
C. Declining balance method
D. Sum of the years digit method
Answer : B

3. The amount of compounded interest during 'n' interest periods is
A. p[(1+i)ⁿ - 1)]
B. p(1 + i)ⁿ
C. p(1 - i)ⁿ
D. p(1 + iⁿ)
Answer : A

4. In declining balance method of depreciation calculation, the
A. Value of the asset decreases linearly with time
B. Annual cost of depreciation is same every year
C. Annual depreciation is the fixed percentage of the property value at the beginning of the particular year
D. None of these
Answer : C

5. An investment of Rs. 100 lakhs is to be made for construction of a plant, which will take two years to start production. The annual profit from the operation of the plant is Rs. 20 lakhs. What will be the payback time?
A. 5 years
B. 7 years
C. 12 years
D. 10 years
Answer : B

6. In an ordinary chemical plant, electrical installation cost may be about
A. 10-15% of purchased equipment cost
B. 3-10% of fixed capital investment
C. Either (A) or (B)
D. Neither (A) nor (B)
Answer : C

7. A balance sheet for an industrial concern shows
A. The financial condition at any given time
B. Only current assets
C. Only fixed assets
D. Only current and fixed assets
Answer : A

8. A series of equal payments (e.g., deposit or cost) made at equal intervals of time is known as
A. Perpetuity
B. Capital charge factor
C. Annuity
D. Future worth
Answer : C

9. According to six-tenths-factor rule, if the cost of a given unit at one capacity is known, then the cost of similar unit with '' times the capacity of the first unit is approximately equal to __________ times the cost of the initial unit.
A. n
B. n0.6
C. n0.4
D. ?n
Answer : B

10. Personnel working in the market research group is responsible for the job of
A. Equipment selection
B. Product evaluation
C. Equipment design
D. Cost estimation
Answer : B

11. 'Lang factor' is defined as the ratio of the capital investment to the delivered cost of major equipments. The value of 'Lang factor' for fixed capital investment, for a solid-fluid processing chemical plant ranges from
A. 1.2 to 1.4
B. 2.5 to 2.7
C. 4.2 to 4.4
D. 6.2 to 6.4
Answer : C

12. Annual depreciation cost are not constant when, the __________ method of depreciation calculation is used.
A. Straight line
B. Sinking fund
C. Present worth
D. Declining balance
Answer : D

13. Fixed capital investment of a chemical plant is the total amount of money needed to supply the necessary plant and manufacturing facilities plus the working capital for operation of the facilities. Which of the following components of fixed capital investment requires minimum percentage of it?
A. Electrical installation cost
B. Equipment installation cost
C. Cost for piping
D. Equipment insulation cost
Answer : D

14. Which of the following elements is not included in the scope of market analysis?
A. Competition from other manufactures
B. Product distribution
C. Opportunities
D. Economics
Answer : D

15. Which of the following is a component of working capital investment?
A. Utilities plants
B. Maintenance and repair inventory
C. Process equipments
D. Depreciation
Answer : B

16. The __________ of a chemical company can be obtained directly from the balance sheet as the difference between current assets and current liabilities.
A. Cash ratio
B. Net working capital
C. Current ratio
D. Liquids assets
Answer : B

17. If 'S' is the amount available after 'n' interest periods for an initial principal 'P' with the discrete compound interest rate 'i', the present worth is given by
A. (1 + i)ⁿ/S
B. S/(1 + i)ⁿ
C. S/(1 + in)
D. S/(1 + n)ⁱ
Answer : B

18. An annuity is a series of equal payments occuring at equal time intervals, and this amount includes the sum of all payments plus interest, if allowed to accumulate at a definite rate of interest from the time of initial payment to the end of annuity term. Ordinary annuity is used in the calculation of the
A. Manufacturing cost
B. Depreciation by sinking fund method
C. Discrete compound interest
D. Cash ratio
Answer : B

19. The 'total capital investment' for a chemical process plant comprises of the fixed capital investment and the
A. Overhead cost
B. Working capital
C. Indirect production cost
D. Direct production cost
Answer : B

20. __________ of depreciation calculation does not take into account the interest on investments.
A. Present worth method
B. Sinking fund method
C. Sum of the years-digits method
D. All (A), (B) and (C)
Answer : C

21. Which of the following is not a current asset of a chemical company?
A. Inventories
B. Marketable securities
C. Chemical equipments
D. None of these
Answer : C

22. The ratio of gross annual sales to the fixed capital investment is termed as the __________ ratio.
A. Cash reserve
B. Capital
C. Turnover
D. Investment
Answer : C

23. Chemical engineering plant cost index is used for finding the present cost of a particular chemical plant, if the cost of similar plant at some time in the past is known. The present cost of the plant = original cost × (index value at present/ index value at time original cost was obtained). The most major component of this cost index is
A. Fabricated equipment and machinery
B. Process instruments and control
C. Pumps and compressor
D. Electrical equipments and material
Answer : A

24. Which of the following relationship is not correct is case of a chemical process plant?
A. Manufacturing cost = direct product cost + fixed charges + plant overhead costs
B. General expenses = administrative expenses + distribution & marketing expenses
C. Total product cost = manufacturing cost + general expenses
D. Total product cost = direct production cost + plant overhead cost
Answer : D

25. Gantt chart (or Bar chart) is helpful in
A. Efficient utilisation of manpower and machines
B. Preparing production schedule
C. Efficient despatching of products
D. Inventory control
Answer : B

26. __________ of depreciation calculation accounts for the interest on investment.
A. Straight line method
B. Declining balance
C. Both (A) and (B)
D. Neither (A) nor (B)
Answer : D

27. Purchased cost of equipments for a chemical process plant ranges from __________ percent of the fixed capital investment.
A. 10 to 20
B. 20 to 40
C. 45 to 60
D. 65 to 75
Answer : B

28. 'Six-tenth factor' rule is used for estimating the
A. Equipment installation cost
B. Equipment cost by scaling
C. Cost of piping
D. Utilities cost
Answer : B

29. Operating profit of a chemical plant is equal to
A. Profit before interest and tax i.e., net profit + interest + tax
B. Profit after tax plus depreciation
C. Net profit + tax
D. Profit after tax
Answer : A

30. Which of the following is the costliest source of getting hydrogen on commercial scale for the manufacture of nitrogenous fertiliser?
A. Coal gasification
B. Steam reforming of naphtha
C. Electrolysis of water
D. Coke oven gas
Answer : C

31. The payback method for the measurement of return on investment
A. Gives a correct picture of profitability
B. Underemphasises liquidity
C. Does not measure the discounted rate of return
D. Takes into account the cash inflows after the recovery of investments
Answer : C

32. Factory manufacturing cost is the sum of the direct production cost
A. Fixed charges and plant overhead cost
B. And plant overhead cost
C. Plant overhead cost and administrative expenses
D. None of these
Answer : A

33. Which of the following is not a component of depreciation cost?
A. Repairs and maintenance cost
B. Loss due to obsolescence of the equipment
C. Loss due to decrease in the demand of product
D. Loss due to accident/breakdown in the machinery
Answer : A

34. Construction expenses are roughly __________ percent of the total direct cost of the plant.
A. 2
B. 10
C. 30
D. 50
Answer : B

35. Utilities cost in the operation of chemical process plant comes under the
A. Plant overhead cost
B. Fixed charges
C. Direct production cost
D. General expenses
Answer : C

36. In a chemical process plant, the total product cost comprises of manufacturing cost and the
A. General expenses
B. Overhead cost
C. R & D cost
D. None of these
Answer : A

37. If an amount R is paid at the end of every year for 'n' years, then the net present value of the annuity at an interest rate of i is
A. R [{(1 + i)ⁿ - 1}/ i ]
B. R [{(1 + i)ⁿ - 1}/ i (1 + i)ⁿ]
C. R(1 + i)ⁿ
D. R/(1 + i)ⁿ
Answer : B

38. Fixed charges for a chemical plant does not include the
A. Interest on borrowed money
B. Rent of land and buildings
C. Property tax, insurance and depreciation
D. Repair and maintenance charges
Answer : D

39. Annual depreciation costs are constant, when the __________ method of depreciation calculation is used.
A. Declining balance
B. Straight line
C. Sum of the years digit
D. None of these
Answer : B

40. Expenditure on research and development (R & D) is categorised as the __________, while making an estimate of the total product cost for a chemical plant.
A. Overhead cost
B. Fixed expenses
C. General expenses
D. Direct production cost
Answer : C

41. Following the six-tenth factor rule, if a loglog plot of capacity of the equipment vs. cost of the equipment is made, then a straight line is obtained, whose slope is equal to
A. 0.1
B. 0.6
C. 0.2
D. 0.8
Answer : B

42. In which of the electric power generation system, the operating cost is minimum?
A. Thermal
B. Nuclear
C. Hydroelectric
D. Fast breeder reactor
Answer : C

43. Relative cost of chemical process plants in India is about __________ percent more than the similar plants in U.S.A.
A. 15
B. 35
C. 55
D. 75
Answer : B

44. A machine has an initial value of Rs. 5000, service life of 5 years and final salvage value of Rs. 1000. The annual depreciation cost by straight line method is Rs.
A. 300
B. 600
C. 800
D. 1000
Answer : C

45. The amount of simple interest during 'n' interest period is (where, i = interest rate based on the length of one interest period, p = principal)
A. p.i.n.
B. p(1 + i.n)
C. p(1 + i)n
D. p(1 - i.n)
Answer : A

46. Pick out the wrong statement.
A. Longer tubes are less expensive per unit heat transfer area as compared to shorter tubes
B. A cost index is merely a number for a given year showing the cost at that time relative to a certain base year
C. Turnover ratio of a chemical plant is the ratio of gross annual sales to the fixed capital investment
D. Plates with butt welded joints are less expensive compared to lap welded joints, because squaring of plates is not necessary
Answer : D

47. Pick out the correct statement.
A. Difference between income and expense is termed as gross revenue
B. Unamortised cost is the difference between the original cost of a property and all the depreciation charges made to date
C. Sum-of-the-years-digits methods of depreciation calculation accounts for the interest on the investment
D. Scrap value is the net amount of money obtainable from the sale of used property over and above any charges involved in its removal & sale
Answer : B

48. Pick out the wrong statement.
A. Debt-equity ratio of a chemical company describes the lenders contribution for each rupee of owner's contribution i.e., debt-equity ratio = total debt/net worth
B. Return on investment (ROI) is the ratio of profit before interest & tax and capital employed (i.e. net worth + total debt)
C. Working capital = current assets + current liability
D. Turn over = opening stock + production closing stock
Answer : C

49. Gross earning is equal to the total income minus
A. Total product cost
B. Fixed cost
C. Income tax
D. None of these
Answer : A

50. A shareholder has __________ say in the affairs of company management compared to a debenture holder.
A. More
B. Less
C. Same
D. No
Answer : A