Heat & Mass Transfer MCQ Solved Paper for SSC Scientific Assistant

1. The unit of overall coefficient of heat transfer is
A. kcal/m²
B. kcal/hr °C
C. kcal/m² hr °C
D. kcal/m hr °C
Answer : C

2. Unit of thermal conductivity in S.I. units is
A. J/m² sec
B. J/m °K sec
C. W/m °K
D. Option (B) and (C) above
Answer : D

3. Total emissivity of polished silver compared to black body is
A. Same
B. Higher
C. More or less same
D. Very much lower
Answer : D

4. According to Stefan Boltzmann law, the total radiation from a black body per second per unit area is directly proportional to the
A. Absolute temperature
B. Square of the absolute temperature
C. Cube of the absolute temperature
D. Fourth power of the absolute temperature
Answer : D

5. A steam pipe is to be insulated by two insulating materials put over each other. For best results
A. Better insulation should be put over pipe and better one over it
B. Inferior insulation should be put over pipe and better one over it
C. Both may be put in any order
D. Whether to put inferior OIL over pipe or the better one would depend on steam temperature
Answer : A

6. The product of Reynolds number and Prandtl number is known as
A. Stanton number
B. Biot number
C. Peclet number
D. Grashoff number
Answer : C

7. According to Dalton's law of partial pressures, (where pb = Barometric pressure, pa = Partial pressure of dry air, and pv = Partial pressure of water vapour)
A. Pb = pa - pv
B. Pb = pa + pv
C. Pb = pa × pv
D. Pb = pa/pv
Answer : B

8. In convection heat transfer from hot flue gases to water tube, even though flow may be turbulent, a laminar flow region (boundary layer of film) exists close to the tube. The heat transfer through this film takes place by
A. Convection
B. Radiation
C. Conduction
D. Both convection and conduction
Answer : C

9. In a heat exchanger with one fluid evaporating or condensing, the surface area required is least in
A. Parallel flow
B. Counter flow
C. Cross flow
D. All of these
Answer : D

10. The emissive power of a body depends upon its
A. Temperature
B. Wave length
C. Physical nature
D. All of the above
Answer : D

11. Absorptivity of a body will be equal to its emissivity
A. At all temperatures
B. At one particular temperature
C. When system is under thermal equilibrium
D. At critical temperature
Answer : C

12. The ratio of surface convection resistance to the internal conduction resistance is known as
A. Grashoff number
B. Biot number
C. Stanton number
D. Prandtl number
Answer : B

13. Two plates spaced 150 mm apart are maintained at 1000°C and 70°C. The heat transfer will take place mainly by
A. Convection
B. Radiation
C. Forced convection
D. Free convection
Answer : B

14. When heat is transferred from hot body to cold body, in a straight line, without affecting the intervening medium, it is referred as heat transfer by
A. Conduction
B. Convection
C. Radiation
D. Conduction and convection
Answer : C

15. The insulation ability of an insulator with the presence of moisture would
A. Increase
B. Decrease
C. Remain unaffected
D. May increase/decrease depending on temperature and thickness of insulation
Answer : B

16. A grey body is one whose absorptivity
A. Varies with temperature
B. Varies with wavelength of the incident ray
C. Is equal to its emissivity
D. Does not vary with temperature and. wavelength of the incident ray
Answer : C

17. Fourier's law of heat conduction gives the heat flow for
A. Irregular surfaces
B. Nonuniform temperature surfaces
C. One dimensional cases only
D. Two dimensional cases only
Answer : C

18. Thermal diffusivity is a
A. Function of temperature
B. Physical property of a substance
C. Dimensionless parameter
D. All of these
Answer : B

19. According to Stefan Boltzmann law, ideal radiators emit radiant energy at a rate proportional to
A. Absolute temperature
B. Square of temperature
C. Fourth power of absolute temperature
D. Fourth power of temperature
Answer : C

20. Thermal diffusivity is
A. A dimensionless parameter
B. Function of temperature
C. Used as mathematical model
D. A physical property of the material
Answer : D

21. A perfect black body is one which
A. Is black in colour
B. Reflects all heat
C. Transmits all heat radiations
D. Absorbs heat radiations of all wave lengths falling on it
Answer : D

22. In heat transfer, conductance equals conductivity (kcal/hr/sq.m/ °C/cm) divided by
A. Hr (time)
B. Sq. m (area)
C. °C (temperature)
D. K.cal (heat)
Answer : D

23. The process of heat transfer from one particle of the body to another is called conduction, when the particles of the body
A. Move actually
B. Do not move actually
C. Affect the intervening medium
D. Does not affect the intervening medium
Answer : B

24. Which of the following is expected to have highest thermal conductivity?
A. Steam
B. Solid ice
C. Melting ice
D. Water
Answer : B

25. Depending on the radiating properties, a body will be white when
A. P = 0, x = 0 and a = 1
B. P=1, T = 0 and a = 0
C. P = 0, x = 1 and a = 0
D. X = 0, a + p = 1 Where a = absorptivity, p = reflectivity, x = transmissivity
Answer : B

26. A composite slab has two layers of different materials with thermal conductivities k? and k?. If each layer has the same thickness, then the equivalent thermal conductivity of the slab will be
A. k? k?
B. (k? + k?)
C. (k? + k?)/ k? k?
D. 2 k? k?/ (k? + k?)
Answer : D

27. The ratio of the energy absorbed by the body to total energy falling on it is called
A. Absorptive power
B. Emissive power
C. Absorptivity
D. Emissivity
Answer : A

28. Thermal conductivity of water in general with rise in temperature
A. Increases
B. Decreases
C. Remain constant
D. May increase or decrease depending on temperature
Answer : D

29. The amount of radiation mainly depends on
A. Nature of body
B. Temperature of body
C. Type of surface of body
D. All of the above
Answer : D

30. Thermal conductivity of glass wool varies from sample to sample because of variation in
A. Composition
B. Density
C. Porosity
D. All of the above
Answer : D

31. The critical thickness of insulation for a sphere is
A. k/h?
B. 2k/h?
C. h?/k
D. h?/2k
Answer : B

32. A steam pipe is to be lined with two layers of insulating materials of different thermal conductivities. For the minimum heat transfer,
A. The better insulation must be put inside
B. The better insulation must be put outside
C. One could place either insulation on either side
D. One should take into account the steam temperature before deciding as to which insulation is put where
Answer : A

33. Fouling factor is used
A. In heat exchanger design as a safety factor
B. In case of Newtonian fluids
C. When a liquid exchanges heat with a gas
D. None of the above
Answer : A

34. A designer chooses the values of fluid flow rates and specific heats in such a manner that the heat capacities of the two fluids are equal. A hot fluid enters the counter flow heat exchanger at 100° C and leaves at 60° C. A cold fluid enters the heat exchanger at 40° C. The mean temperature difference between the two fluids is
A. 20°C
B. 40°C
C. 60°C
D. 66.7°C
Answer : A

35. Two long parallel surfaces each of emissivity 0.7 are maintained at different temperatures and accordingly have radiation heat exchange between them. It is desired to reduce 75% of the radiant heat transfer by inserting thin parallel shields of emissivity 1 on both sides. The number of shields should be
A. One
B. Two
C. Three
D. Four
Answer : C

36. Thermal conductivity of air with rise in temperature
A. Increases
B. Decreases
C. Remain constant
D. May increase or decrease depending on temperature
Answer : A

37. Thermal conductivity of water ________ with rise in temperature.
A. Remain same
B. Decreases
C. Increases
D. May increase or decrease depending upon temperature
Answer : D

38. The natural convection air cooled condensers are used in
A. Domestic refrigerators
B. Water coolers
C. Room air conditioners
D. All of these
Answer : A

39. Thermal diffusivity of a substance is
A. Directly proportional to the thermal conductivity
B. Inversely proportional to density of substance
C. Inversely proportional to specific heat
D. All of the above
Answer : D

40. According to Prevost theory of heat exchange
A. It is impossible to transfer heat from low temperature source to t high temperature source
B. Heat transfer by radiation requires no medium
C. All bodies above absolute zero emit radiation
D. Heat transfer in most of the cases takes place by combination of conduction, convection and radiation
Answer : C

41. A cube at high temperature is immersed in a constant temperature bath. It loses heat from its top, bottom and side surfaces with heat transfer coefficients of h?, h? and h? respectively. The average heat transfer coefficient for the cube is
A. h? + h? + h?
B. (h?.h?.h?)1/3
C. 1/h? + 1/h? + 1/h?
D. None of these
Answer : D

42. According to Newton's law of cooling, the heat transfer from a hot body to a cold body is
A. Directly proportional to the surface area
B. Directly proportional to the difference of temperatures between the two bodies
C. Either (A) or (B)
D. Both (A) and (B)
Answer : D

43. Kirchhoff's law states that
A. The total radiation from a black body per second per unit area is directly proportional to the fourth power of the absolute temperature
B. The wave length corresponding to the maximum energy is proportional to the absolute temperature
C. The ratio of the emissive power and absorptive power of all bodies is the same and is equal to the emissive power of a perfectly black body
D. None of the above
Answer : C

44. The heat is transferred by conduction, convection and radiation in
A. Melting of ice
B. Boiler furnaces
C. Condensation of steam in condenser
D. None of these
Answer : B

45. In heat exchangers, degree of approach is defined as the difference between temperatures of
A. Cold water inlet and outlet
B. Hot medium inlet and outlet
C. Hot medium outlet and cold water inlet
D. Hot medium outlet and cold water outlet
Answer : D

46. In counter flow heat exchangers
A. Both the fluids at inlet (of heat exchanger where hot fluid enters) are in their coldest state
B. Both the fluids at inlet are in their hottest state
C. Both the fluids at exit are in their hottest state
D. One fluid is in hottest state and other in coldest state at inlet
Answer : B

47. The thermal diffusivities for gases are generally
A. More than those for liquids
B. Less than those for liquids
C. More than those for solids
D. Dependent on the viscosity
Answer : A

48. The ratio of Nusselt number and the product of Reynold's number and Prandtl number is equal to
A. Stanton number
B. Biot number
C. Peclet number
D. Grashoff number
Answer : A

49. Which of the following is the case of heat transfer by radiation?
A. Blast furnace
B. Heating of building
C. Cooling of parts in furnace
D. Heat received by a person from fireplace
Answer : D

50. The value of the wavelength for maximum emissive power is given by
A. Wien's law
B. Planck's law
C. Stefan's law
D. Fourier's law
Answer : A