Related Questions
What is the correct answer?
4
This is used to indicate that a surface is to be machined:
What is the correct answer?
4
Oblique drawings are dimensioned in a similar fashion as these types of drawings:
What is the correct answer?
4
A full scale technical drawing will have a scale factor of ________.
What is the correct answer?
4
This practice considers an individual part's dimensions and tolerances and that part's relation to its related parts:
B. Geometric dimensioning and tolerancing
C. Creating datum references
D. Angular dimensioning tolerances
What is the correct answer?
4
When filling an area with a hatch pattern in Auto-CAD the drafter needs to be able to ________.
A. See the entire bounding area to hatch
D. Set the layer to Defpoints
What is the correct answer?
4
Center lines are used to locate or represent the centers of ________.
What is the correct answer?
4
These types of pipes are generally connected with bell and spigot joints or flanged joints:
What is the correct answer?
4
The site plan illustrates ________.
B. Where the house sits on the property
D. Where the garage and driveway are located
What is the correct answer?
4
The most common geometric form used in gears today is this:
What is the correct answer?
4
To insure that everyone understands what the electrical symbols represent it is customary to include a ________ on the electrical sheet.
What is the correct answer?
4
Acceptable parts must not extend beyond this:
What is the correct answer?
4
In some circumstances an entire drawing can be inserted into a different drawing as a block. When this is used the base point will default to ________.
What is the correct answer?
4
The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.
What is the correct answer?
4
Which of the following is one of the basic types of welded joints:
What is the correct answer?
4
This type of solid has two bases that are parallel equal polygons:
What is the correct answer?
4
There should be a visible gap between the wall and the ________ line.
What is the correct answer?
4
The Conceptual Visual Style tool is located on the ________ toolbar.
What is the correct answer?
4
This is the measured size of a finished part:
What is the correct answer?
4
When creating a block the drafter needs to pay particular attention to selecting a base point because it determines the ________.
What is the correct answer?
4
A line with a tapering width can be easily created by using the __________ tool.
What is the correct answer?
4
Baseline dimensions are referenced from a common geometric feature known as a ________.
What is the correct answer?
4
To avoid having to dimension to a hidden feature the drafter can utilize a ________ section.
What is the correct answer?
4
The ________ dimension tool will place the length of an angled line.
What is the correct answer?
4
This type of solid is formed by sweeping a shape along a linear path:
What is the correct answer?
4
If designs require changes, they should be documented with:
D. Engineering change orders
What is the correct answer?
4
Architectural dimensioning standards allow for the placement of dimensions inside the floor plan. These inside dimensions locate interior __________.
A. Door openings and walls
What is the correct answer?
4
The edges of a cube in isometric projection make angles of this many degrees with each other:
What is the correct answer?
4
In isometric projection, all distances are approximately this percentage of their true size:
What is the correct answer?
4
This type of projection is when projectors are parallel to each other, but is at an angle other than 90 degrees to the plane of projection:
B. Perpendicular projection
What is the correct answer?
4
An oil refinery relies on which type of drafter to maintain and update the technical piping drawings used for the construction and maintenance of the facility.