Lower deviation is zero
Upper deviation is zero
Lower and upper deviations are zero
None of these
B. Upper deviation is zero
Wooden nails
Box nails
Wire nails
None of these
Tensile strength
Yield strength
Hardness
All of these
Collapsibility
Permeability
Cohesiveness
Adhesiveness
Rough file
Bastard file
Second cut file
Smooth file
Actual deviation
Upper deviation
Lower deviation
Fundamental deviation
±0.05 mm
+0.2 mm
+05 mm
+1 mm
One is working roll and three are backing up rolls
Two are working rolls and two are backing up rolls
Three are working rolls and one is backing up roll
All of the four are working rolls
Shearing
Piercing
Punching
Blanking
Steel, cast iron, copper, aluminium etc
Brass and bronze
Hard surfacing materials such as stellite
All of these
Collapsibility
Permeability
Cohesiveness
Adhesiveness
Smoothing and cleaning out depressions in the mould
Cleaning the moulding sand
Moistening the sand around the edge before removing pattern
Reinforcement of sand in the top part of the moulding box
Continuous spot welding process
Multi-spot welding process
Arc welding process
Process used for joining round bars
1000°C
1250°C
2100°C
3200°C
Drag
Cheek
Cope
None of these
Is extensively used for making bolts and nuts
Is used for reducing the diameter of round bars and tubes by rotating dies which open and close rapidly on the work
Is used to improve fatigue resistance of the metal by setting up compressive stresses in its surface
Consists of pressing the metal inside a chamber to force it out by high pressure through an orifice which is shaped to provide the desired form of the finished part
Low melting temperature
High melting temperature
Both (A) and (B)
None of these
Galvanising
Anodising
Parkerising
Sherardizing
Plunging
Notching
Slitting
Forming
Varying the input supply
Changing the primary turns of the transformer
Changing the secondary turns of the transformer
Any one of the above
Deliver molten metal into the mould cavity
Act as a reservoir for the molten metal
Feed the molten metal to the casting in order to compensate for the shrinkage
Deliver the molten metal from pouring basin to gate
Light in weight
Easy to work
Corrosion resistant
All of these
Neutral flame
Oxidising flame
Carburising flame
All of these
Is a two man saw
Is used for cutting along the grains of wood
Has a narrow blade with two wooden handles
All of the above
Black colour
White colour
Maroon colour
Yellow colour
Simple die
Progressive die
Combination die
Compound die
Outside micrometer
Inside micrometer
Depth gauge micrometer
Vernier caliper
Poor surface finish is produced
Scale is formed on the metal surface
Close tolerances cannot be maintained
All of these
The upper and middle rolls rotate in the same direction whereas the bottom roll rotates in opposite direction
The upper and bottom rolls rotate in the same direction whereas the middle roll rotates in opposite direction
The bottom and middle roll rotate in the same direction
Any one of the above
d
1.5d
3d
6d
1800°C
2100°C
2400°C
3200°C