Home

A cantilever beam is one which is

A. Fixed at both ends

B. Fixed at one end and free at the other end

C. Supported at its ends

D. Supported on more than two supports

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Stirling cycle consists of
  2. The compression ratio for Diesel engines is
  3. The state of stress at a point in a loaded member is shown in the below figure. The magnitude of maximum…
  4. The maximum bending moment for the beam shown in the below figure, is
  5. The efficiency of Joule cycle is
  6. A bar of copper and steel form a composite system, which is heated to a temperature of 40°C. The…
  7. Coke is produced
  8. If the slenderness ratio for a column is 100, then it is said to be a _________ column.
  9. Otto cycle consists of
  10. Tensile strength of a material is obtained by dividing the maximum load during the test by the
  11. The fuel mostly used in cement industry and in metallurgical processes is
  12. An open system is one in which
  13. The thermal efficiency of an ideal gas turbine plant is given by (where r = Pressure ratio)
  14. When a gas is heated, change takes place in
  15. The amount of heat required to raise the temperature of __________ water through one degree is called…
  16. The entropy of water at 0°C is assumed to be
  17. Mond gas is obtained by
  18. Which of the following statement is wrong?
  19. The deformation per unit length is called
  20. Which of the following is an intensive property of a thermodynamic system?
  21. In the tensile test, the phenomenon of slow extension of the material, i. e. stress increasing with…
  22. If the depth is kept constant for a beam of uniform strength, then its width will vary in proportional…
  23. In an extensive property of a thermodynamic system
  24. The variables which control the physical properties of a perfect gas are
  25. When a rectangular beam is loaded transversely, the maximum compressive stress is developed on the
  26. One kg of carbon requires 4/3 kg of oxygen and produces __________ kg of carbon monoxide gas.
  27. The standard value of atmospheric pressure taken at sea level is
  28. The sum of internal energy (U) and the product of pressure and volume (p.v) is known as
  29. Which of the following is the extensive property of a thermodynamic system?
  30. For the same compression ratio, the efficiency of dual combustion cycle is