A capacitive load always has a ______ power facto

A. Leading

B. Lagging

C. Zero

D. Unity

Related Questions

  1. The power factor of a circuit is equal to
  2. The average value of a triangular or sawtooth wave is _____ times its peak value.
  3. Which of the following capacitors has the highest cost per F?
  4. Which of the following is the statement of Ohms law?
  5. The presence of an electric current is made known by
  6. An open inductor has
  7. Which of the following dielectric materials makes the lowest-capacitance capacitor?
  8. Under the conditions of maximum power transfera a voltage source is delivering a power of 15 W to the…
  9. When the temperature of copper wire is increased its resistance is
  10. What is the purpose of a load in an electric circuit?
  11. Which is considered as the effect of a dielectric material?
  12. An alloy composed of 84 % coppera 12 % manganese and 4 % nickel.
  13. Which of the following is a disadvantage of a wire-wound resistor?
  14. What is the most convenient way of achieving large capacitance?
  15. For a triangular and sawtooth waveform the rms voltage or current equals
  16. In an ac wavea 30 degrees of phase is ___ of a cycle.
  17. Nortons theorem is ____ Thevenins theorem.
  18. The unit of elastance is
  19. The resistance of an insulator ___ when its temperature is increased.
  20. If two complex conjugates are addeda ___ components results.
  21. Which of the following is a way of decreasing mutual inductance?
  22. The curve between current and frequency is termed as
  23. If the inductance is decreaseda the impedance of the circuit containing a resistor a capacitor and an…
  24. At parallel resonancea the currents flowing through L and C are
  25. The ratio of W/VA in an ac circuit means
  26. The ratio between the reactive power and the apparent power of an ac load is called
  27. Which of the following is neither a basic physical law nor deliverable from one?
  28. In a rectangular wavea the peak factor is
  29. For greater accuracya the value of phase angle should be determined from
  30. VL= VCin a series RLCcircuit when

Please do not use chat terms. Example: avoid using "grt" instead of "great".