Related Questions
What is the correct answer?
4
When the movable plates of a gang capacitor completely overlap the fixed platesa the capacitance of the capacitor is
A. Halfway between maximum and minimum
What is the correct answer?
4
For a linear circuita ___ voltage or current is used to calculate average power.
What is the correct answer?
4
As applied to a series RLCcircuita bandwidth means
A. The frequency range for maximum power transfer
B. The difference between the highest and lowest frequencies of the oscillator
C. The separation of the half-power points
D. The frequency at which XL= XC
What is the correct answer?
4
Another term of the quality factor of the resonant circuit.
What is the correct answer?
4
In a complex number 5 + j 10a 10 is called ___ part.
What is the correct answer?
4
Effects of capacitance
A. It opposes any change in the amount of voltage
B. Voltage is lagged behind the current by a quarter cycle
C. Electric energy is stored in the capacitor in the form of electrostatic field
What is the correct answer?
4
A trimmer is a variable capacitor in which capacitance is varied by changing the
C. Distance between plates
What is the correct answer?
4
An inductive load always has a ___ power factor
What is the correct answer?
4
A series RLCcircuit consists of a 10 resistor in series with L = 10 Ha and C= 100 F. Determine a new value of Ia for which the resonant frequency is one ±half the original value.
What is the correct answer?
4
Which of the following is not a factor affecting dielectric strength?
What is the correct answer?
4
When capacitors are connected in seriesa the total capacitance is
A. Smaller than the smallest capacitor
B. Smaller than the largest capacitor
C. Greater than any of the capacitor
D. Greater than the largest capacitor
What is the correct answer?
4
If an emf in circuit A produces a current in circuit Ba then the same emf in circuit Bproduces the same current in circuit ? this theorem is known as
A. Maximum power transfer theorem
What is the correct answer?
4
Parallel resonant circuit is sometimes called as
What is the correct answer?
4
In adding or subtracting phasor quantitiesa ___ form is the most convenient.
What is the correct answer?
4
Which of the following is a common material used in wire-wound resistors?
What is the correct answer?
4
Metal tin becomes superconductor at approximately
What is the correct answer?
4
The impedance in the study of electronics is represented by resistan
C. Inductance and capacitance
What is the correct answer?
4
Why are inductance and capacitance not relevant in a dc circuit?
A. Because it is a simple circuit
B. Because dc circuits require only resistance as load
C. Because they do not exist in a dc circuit
D. Because frequency of dc is zero
What is the correct answer?
4
What is the total capacitance of 10 capacitorsa each of 20 F in series?
What is the correct answer?
4
The mutual inductance between two coils is ___ the reluctance of magnetic path.
A. Directly proportional to
B. Inversely proportional to
What is the correct answer?
4
At what frequency will the current in a series RLCcircuit reach its maximum value for an applied voltage of 15 V with R = 500 a L = 100 H and C= 0.001 F?
What is the correct answer?
4
For parallel capacitorsa total charge is
A. The sum of individual charges
B. Equal to the charge of either capacitors
C. Equal to the product of the charges
D. The quotient of the charges
What is the correct answer?
4
Delta to wye or wye to delta transformation technique is applied to a ___ network.
What is the correct answer?
4
A resistor wound with a wire doubled back on itself to reduce the inductance.
C. Anti-inductive resistor
What is the correct answer?
4
In dividing or multiplying phasor quantitiesa ___ form is used.
What is the correct answer?
4
What is the hot resistance of a 100 Wa 220 V incandescent lamp?
What is the correct answer?
4
Tungsten filament of bulbs has a hot resistance higher than its cold resistance due to its temperature coefficient which is
What is the correct answer?
4
Barium-strontium titanite dielectric material is also called
What is the correct answer?
4
The maximum power transfer theorem is used in
What is the correct answer?
4
For a series circuita the higher the quality factor
A. The greater the bandwidth
B. The narrower the passband
C. The broader the resonance curve
D. The wider the passband