A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
Architectural
Civil
Mechanical
Process piping
- The organized and orderly approach to solving problems is known as the:
- This practice considers an individual part's dimensions and tolerances and that part's relation to its…
- When filling an area with a hatch pattern in Auto-CAD the drafter needs to be able to ________.
- This is an angled surface used on cylinders to make them easier to handle:
- On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
- Some common blocks used by architectural drafters include ________.
- Approximately this much of the cost of product development and manufacture is determined at the design…
- Geometric primitives include shapes such as ________.
- There should be a visible gap between the wall and the ________ line.
- The MASSPROP shortcut will provide the following information.
- In this type of drawing, vertical pipes may be revolved into the horizontal plane:
- This is a curve showing the displacement of the follower as ordinates on a base line that represents…
- In isometric projection, all distances are approximately this percentage of their true size:
- This is the smallest diameter of a screw thread:
- Architectural dimensioning is usually done in ________.
- When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate…
- In an assembly section, these parts should have their section lines left out or shown solid black:
- When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
- The text used on a typical detail sheet should be ________.
- This process recognizes the inherent interrelationships between design and manufacturing:
- These are special installations of stone or concrete marking the locations of points accurately determined…
- Architectural drafters generally prefer to use ________ drawings to help illustrate 3-dimensional views…
- When positioning this feature of perspective projection, the centerline of the cone of visual rays should…
- Some of the standard Auto-CAD text styles used in architectural drawings includes ________.
- In the section view, the areas that would have been in actual contact with the cutting plane are shown…
- Spur gear design normally begins with selecting this:
- Generally, the units used on an architectural drawing are set to ________.
- A civil engineer working on a bridge design would probably rely on his ________ scale for checking printed…
- Baseline dimensions are referenced from a common geometric feature known as a ________.
- Dimensions are used on the elevation plan to describe ________.