Holds and locates a workpiece and guides and controls one or more cutting tools
Holds and locates a workpiece during an inspection or for a manufacturing operation
Is used to check the accuracy of workpiece
All of the above
B. Holds and locates a workpiece during an inspection or for a manufacturing operation
Of maximum diameter 15 mm
In 15 mm thick plates
Having cross-sectional area of 15 mm²
None of these
Equal to
One-fourth
One-half
Double
Hardness of abrasive grains
Ability of the bond to retain abrasives
Hardness of the bond
Ability of the grinding wheel to penetrate the work piece
It improves tool life
It improves the surface finish
Both (A) and (B)
None of these
Internal cylindrical grinding
Form grinding
External cylindrical grinding
Surface grinding
It can machine hardest materials.
It produces high degree of surface finish.
The tool and work are never in contact with each other.
All of these
Mild steel
Alloy steel
Pig iron
Chilled cast iron
The workpiece is supported throughout its entire length as grinding takes place.
It is a continuous process and adopted for production work.
It requires no holding device for the work.
All of the above
Wattmeter
Dynamometer
Hydrometer
Pyrometer
Continuous chips are formed
Discontinuous chips are formed
Continuous chips with built-up edge are formed
No chips are formed
Greater than the upper limit of the hole
Lesser than the upper limit of the hole
Greater than the lower limit of the hole
Lesser than the lower limit of the hole
90°
118°
135°
150°
By a form tool
By setting over the tail stock
By a taper turning attachment
By swivelling the compound rest
Cool the tool
Improve surface finish
Cool the workpiece
All of these
Side cutting tool
Front cutting tool
End cutting tool
None of these
Rake angle
Cutting angle
Lip angle
All of these
Roughing teeth
Semi-finishing teeth
Finishing teeth
All of these
Minimum at the beginning of the cut and maximum at the end of the cut
Maximum at the beginning of the cut and minimum at the end of the cut
Uniform throughout the cut
None of these
Ceramic
Stellite
Diamond
Cemented carbide
(4π/6)³ × (r/l)⁶
(4π/6) × (r/l)²
(4π/6)² × (r/l)³
(4π/6)² × (r/l)⁴
Arithmetical progression
Geometrical progression
Harmonical progression
Any one of these
Conventional milling
Climb milling
End milling
Face milling
500 to 1000
1000 to 1500
1500 to 2000
2000 to 2500
Profile milling
Gang milling
Saw milling
Helical milling
Profile milling
Gang milling
Saw milling
Helical milling
Making a cone-shaped enlargement of the end of a hole
Smoothing and squaring the surface around a hole
Sizing and finishing a small diameter hole
Producing a hole by removing metal along the circumference of a hollow cutting tool
Tungsten carbide
Brass or copper
Diamond
Stainless steel
Length between centres
Swing diameter over the bed
Swing diameter over the carriage
All of these
After heat treatment
Prior to heat treatment
For gear reconditioning
None of these
Course grained
Medium grained
Fine grained
None of these