A ___________ in a bit position of a wildcard mask means that the same bit position in the condition address must match the same bit position in the wildcard mask in order to execute the ACL's action.

A. 0

B. 1

C. 10

D. 11

Related Questions

  1. Which of the following commands belongs on the physical interface when using dialer profiles?
  2. You execute the line console 0 command from Configuration mode. What will the router's prompt be?
  3. The 1900 switch supports ________ VLANs.
  4. Which 2950 command assigns a VLAN to an interface?
  5. Which of the following are not features of ACLs?
  6. Which router command specifies the ISDN switch the router is connected to?
  7. Frames sent above the __________ limit will have their _________ bit set.
  8. You are at User EXEC mode and type the letter e. What message appears?
  9. BPDU stands for ____________.
  10. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  11. Which router command would take you back to a suspended telnet session?
  12. If the port status LED on a 2950 is ________, there is a physical layer connection problem.
  13. The _______ program goes out and finds the IOS and loads it.
  14. Which IGRP command allows unequal-cost load balancing?
  15. When configuring your terminal emulation software for a console connection, set the flow control to…
  16. Which of the following is the most expensive type of WAN connection?
  17. Your router is running RIP and OSPF and both routing protocols are learning Which routing…
  18. Distance vector protocols use ___________ to disseminate routing information.
  19. If the 2950's RPS is ________, the external power supply is supplying power.
  20. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  21. Which prompt indicates that you are at User EXEC mode?
  22. Which command takes you from Privilege EXEC mode to User EXEC mode?
  23. Which router command would you use to test only layer-3 connectivity?
  24. Which type of routing protocol uses the Shortest Path First algorithm?
  25. The OSPF process ID is __________.
  26. Which router command performs an overwrite process? (Choose all correct answers.)
  27. When setting up an RJ-45 console connection, you need a RJ-45-to-DB-9 __________ adapter to attach to…
  28. Which of the following trunking methods is/are proprietary to Cisco?
  29. Which frame field is different between ISO HDLC and Cisco's HDLC?
  30. What would you enter to see the last few commands you entered?

Please do not use chat terms. Example: avoid using "grt" instead of "great".