Related Questions
What is the correct answer?
4
The switch port that is chosen to forward traffic for a segment is called a __________.
What is the correct answer?
4
When configuring a router-on-a-stick, the configuration is done on __________.
What is the correct answer?
4
Which of the following is stored in ROM? (Choose all correct answers.)
What is the correct answer?
4
RIP has a maximum hop count of ____________ hops.
What is the correct answer?
4
A ___________ in a bit position of a wildcard mask means that the same bit position in the condition address must match the same bit position in the wildcard mask in order to execute the ACL's action.
What is the correct answer?
4
Which of the following WAN categories does ISDN fall under?
A. Dedicated circuit connection
B. Circuit-switched connection
C. Packet-switched connection
What is the correct answer?
4
Which control sequence moves the cursor to the end of the line?
What is the correct answer?
4
_________ has a physical star topology but a logical ring topology.
What is the correct answer?
4
Which 2950 command assigns a VLAN to an interface?
A. vlan-membership static
C. switchport access vlan
D. switchport mode access
What is the correct answer?
4
When configuring your terminal emulation software for a console connection, set the flow control to __________.
What is the correct answer?
4
What must you do to enable IP routing on your router? (Choose all of the correct answers.)
A. Enable the routing protocol.
B. Set clocking on all serial interfaces.
C. Assign IP addresses to your router's interfaces.
D. Assign the bandwidth parameter to your serial interfaces
What is the correct answer?
4
Distance vector protocols use ___________ to disseminate routing information.
What is the correct answer?
4
A __________ route is the best path to reach a destination within the topology table.
What is the correct answer?
4
_________ describe(s) users that can connect to a network from any location.
What is the correct answer?
4
What would you enter to see the last few commands you entered?
What is the correct answer?
4
The _________ reference point defines the connection between the NT2 and the NT1.
What is the correct answer?
4
Which of the following is not an advantage of route summarization?
A. It requires less memory and processing.
B. It supports smaller routing update sizes.
C. It contains network problems.
D. It supports discontiguous subnets.
What is the correct answer?
4
You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks with 30 hosts. What are the subnet mask values you could use?
A. 255.255.255.128 and 255.255.255.192
B. 255.255.255.224 and 255.255.255.240
C. 255.255.255.192 and 255.255.255.224
What is the correct answer?
4
With a crossover cable, which pins are crossed over?
What is the correct answer?
4
What would you use to prevent a packet from traveling around a routing loop forever?
What is the correct answer?
4
If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
What is the correct answer?
4
Which of the following reasons might you need to use address translation?
A. You have to use public addressing because your ISP didn't assign you enough private addresses.
B. You are using private addresses but have changed ISPs, and your new ISP won't support these private addresses.
C. You want to assign the same IP address to multiple machines so that users on the Internet see this offered service as a single logical computer.
D. You are merging two companies that use different address spaces.
What is the correct answer?
4
When using the show interfaces command, which Frame Relay information can you not see?
A. The DLCI number used for LMI
B. The number of LMIs sent and received
What is the correct answer?
4
Which of the following is true concerning RIPv2?
A. It uses triggered updates.
D. It doesn't support route summarization
What is the correct answer?
4
IOS images can be loaded from all the following except:
What is the correct answer?
4
Enter the wildcard mask value to match on every bit position in an address: _________.
What is the correct answer?
4
A _________ routes between different autonomous systems.
What is the correct answer?
4
You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol is down. What does this indicate?
A. There is a physical layer problem.
B. There is a data link layer problem.
C. There is a network layer problem.
What is the correct answer?
4
RIP has a hold-down period of ____________ seconds.
What is the correct answer?
4
Which of the following is true concerning ISL?
A. It is supported on both the 1900 and 2950 switches.
B. It adds a 26-byte trailer and 4-byte header.
C. Tagging is done in software.
D. The original Ethernet frame is not modified.