Home
Current Affairs January 2024

What is the correct answer?

4

A number of forces acting at a point will be in equilibrium, if

A. All the forces are equally inclined

B. Sum of all the forces is zero

C. Sum of resolved parts in the vertical direction is zero (i.e. ΣV = 0)

D. None of these

Correct Answer :

C. Sum of resolved parts in the vertical direction is zero (i.e. ΣV = 0)


Related Questions

What is the correct answer?

4

Center of percussion is

A. The point of C.G.

B. The point of metacenter

C. The point of application of the resultant of all the forces tending to cause a body to rotate about a certain axis

D. Point of suspension

What is the correct answer?

4

The time of flight (t) of a projectile on an upward inclined plane is (where u = Velocity of projection, α = Angle of projection, and β = Inclination of the plane with the horizontal.)

A. t = g cos β/2u sin (α - β)

B. t = 2u sin (α - β)/g cos β

C. t = g cos β/2u sin (α + β)

D. t = 2u sin (α + β)/g cos β

What is the correct answer?

4

If the masses of both the bodies, as shown in the below figure, are reduced to 50 percent, then tension in the string will be

A. Same

B. Half

C. Double

D. None of these

What is the correct answer?

4

Pick up the incorrect statement from the following:

A. The C.G. of a circle is at its centre

B. The C.G. of a triangle is at the intersection of its medians

C. The C.G. of a rectangle is at the intersection of its diagonals

D. The C.G. of a semicircle is at a distance of r/2 from the centre

What is the correct answer?

4

A block of mass 20 kg lying on a rough horizontal plane is connected by a light string passing over a smooth pulley to another mass 5 kg, which can move freely in the Vertical direction, as shown in the below figure. The tension in the string will __________ with the increase in coefficient of friction.

A. Increase

B. Decrease

C. Not be effected

D. None of these

What is the correct answer?

4

The unit of force in S.I. system of units is

A. Dyne

B. Kilogram

C. Newton

D. Watt

What is the correct answer?

4

In the shown figure, if the angle of inclination of the plane is increased, then acceleration of the system will

A. Increase

B. Decrease

C. Remain the same

D. None of these

What is the correct answer?

4

On a ladder resting on smooth ground and leaning against vertical wall, the force of friction will be

A. Towards the wall at its upper end

B. Away from the wall at its upper end

C. Upwards at its upper end

D. Downwards at its upper end

What is the correct answer?

4

The slope on the road surface generally provided on the curves is known as

A. Angle of friction

B. Angle of repose

C. Angle of banking

D. None of these

What is the correct answer?

4

From a circular plate of diameter 6 cm is cut out a circle whose diameter is a radius of the plate. Find the e.g. of the remainder from the centre of circular plate

A. 0.5 cm

B. 1.0 cm

C. 1.5 cm

D. 2.5 cm

What is the correct answer?

4

The skidding away of the vehicle on a level circular path can be avoided if the force of friction between the wheels and the ground is __________ the centrifugal force.

A. Less than

B. Greater than

C. Equal to

D. None of these

What is the correct answer?

4

The energy possessed by a body, for doing work by virtue of its position, is called

A. Potential energy

B. Kinetic energy

C. Electrical energy

D. Chemical energy

What is the correct answer?

4

Moment of inertia of a hollow circular section, as shown in the below figure about an axis perpendicular to the section, is __________ than that about X-X axis.

A. Two times

B. Same

C. Half

D. None of these

What is the correct answer?

4

The acceleration of a particle moving with simple harmonic motion, at any instant is given by

A. ω.y

B. ω2.y

C. ω2/y

D. ω3.y

What is the correct answer?

4

A sample of metal weighs 219 gms in air, 180 gms in water, 120 gms in an unknown fluid. Then which is correct statement about density of metal

A. Density of metal can't be determined

B. Metal is twice as dense as water

C. Metal will float in water

D. Metal is twice as dense as unknown fluid

What is the correct answer?

4

The centre of gravity of a right circular solid cone is at a distance of __________ from its base, measured along the vertical axis. (where h = Height of a right circular solid cone.)

A. h/2

B. h/3

C. h/4

D. h/6

What is the correct answer?

4

A projectile is fired at an angle θ to the vertical. Its horizontal range will be maximum when θ is

A.

B. 30°

C. 45°

D. 60°

What is the correct answer?

4

A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is μ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will

A. Remain horizontal

B. Slant up towards direction of pull

C. Slant down towards direction of pull

D. None of the above

What is the correct answer?

4

If a body is acted upon by a number of coplanar non-concurrent forces, it may

A. Rotate about itself without moving

B. Move in any one direction rotating about itself

C. Be completely at rest

D. All of these

What is the correct answer?

4

Which of the following statement is correct?

A. The kinetic energy of a body during impact remains constant.

B. The kinetic energy of a body before impact is equal to the kinetic energy of a body after impact.

C. The kinetic energy of a body before impact is less than the kinetic energy of a body after impact.

D. The kinetic energy of a body before impact is more than the kinetic energy of a body after impact.

What is the correct answer?

4

A body moves, from rest with a constant acceleration of 5 m per sec. The distance covered in 5 sec is most nearly

A. 38 m

B. 62.5 m

C. 96 m

D. 124 m

What is the correct answer?

4

A machine having an efficiency greater than 50%, is known as

A. Reversible machine

B. Non-reversible machine

C. Neither reversible nor non-reversible machine

D. Ideal machine

What is the correct answer?

4

If three forces acting in different planes can be represented by a triangle, these will be in

A. Non-equilibrium

B. Partial equilibrium

C. Full equilibrium

D. Unpredictable

What is the correct answer?

4

According to the law of moments, if a number of coplanar forces acting on a particle are in equilibrium, then

A. Their algebraic sum is zero

B. Their lines of action are at equal distances

C. The algebraic sum of their moments about any point in their plane is zero

D. The algebraic sum of their moments about any point is equal to the moment of their resultant force about the same point.

What is the correct answer?

4

The mechanical advantage of a lifting machine is the ratio of

A. Distance moved by effort to the distance moved by load

B. Load lifted to the effort applied

C. Output to the input

D. All of the above

What is the correct answer?

4

Least force required to draw a body up the inclined plane is W sin (plane inclination + friction angle) applied in the direction

A. Along the plane

B. Horizontally

C. Vertically

D. At an angle equal to the angle of friction to the inclined plane

What is the correct answer?

4

According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through centre of gravity (i.e. IP) is given by(where, A = Area of the section, IG = Moment of inertia of the section about an axis passing through its C.G., and h = Distance between C.G. and the parallel axis.)

A. IP = IG + Ah2

B. IP = IG - Ah2

C. IP = IG / Ah2

D. IP = Ah2 / IG

What is the correct answer?

4

The forces, whose lines of action are parallel to each other and act in the same directions, are known as

A. Coplanar concurrent forces

B. Coplanar non-concurrent forces

C. Like parallel forces

D. Unlike parallel forces

What is the correct answer?

4

The velocity ratio in case of an inclined plane inclined at angle θ to the horizontal and weight being pulled up the inclined plane by vertical effort is

A. sinθ

B. cosθ

C. tanθ

D. cosecθ

What is the correct answer?

4

The force, by which the body is attracted, towards the centre of the earth, is called

A. Impulsive force

B. Mass

C. Weight

D. Momentum