Home

A __________ route is the best path to reach a destination within the topology table.

A. Successor

B. Feasible successor

C. Advertised distance

D. Feasible distance

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Which VTP mode(s) will propagate VTP messages?
  2. _________ defines how the Frame Relay DTE and DCE interact with each other.
  3. Which 1900 command enables port security?
  4. An _____________ is a public IP address associated with an inside device.
  5. Which command activates an IP ACL on a router's interface?
  6. _________ describe(s) users working from home.
  7. You are given this address space: 172.16.5.0/25. You need one network with 64 hosts and two with 30…
  8. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  9. Which command is used to define the local addresses that are statically translated to global addresses?
  10. OSPF hellos are sent every __________ seconds on a multi-access medium.
  11. Choose the following that a standard IP ACL can match on.
  12. The slot number of a 1900's Fast Ethernet uplink ports is ________.
  13. When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.
  14. Which of the following is false concerning OSPF?
  15. During the learning function, the switch places addresses and ports in a(n) _________ table.
  16. When choosing a dynamic routing protocol, which of the following should not be considered?
  17. An OSPF's router ID is based on __________.
  18. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
  19. How many steps do LCP and NCP go through when setting up a connection?
  20. Which command defines interesting traffic?
  21. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  22. A _________ routes between different autonomous systems.
  23. The 1900 switch supports ________ VLANs.
  24. The _______ program goes out and finds the IOS and loads it.
  25. The dialer map command contains all of the following parameters except __________.
  26. When configuring a router-on-a-stick, the configuration is done on __________.
  27. Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing…
  28. VLSM allows a network segment to have more than one subnet mask.
  29. A __________ route is the best path to reach a destination within the topology table.
  30. If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize,…