Home

A routing protocol that supports route summarization must perform all except which of the following?

A. Carry the subnet mask with the network entry.

B. Make routing decisions based on the entire destination IP address.

C. Summarize entries so that the same lowest-order bits match.

D. None of these.

You can do it
  1. Which of the following is the most expensive type of WAN connection?
  2. RIP supports load balancing for up to __________ ___________ paths.
  3. How would you suspend a telnet session?
  4. During the learning function, the switch places addresses and ports in a(n) _________ table.
  5. A _________ connects two or more LANs in the same geographic area.
  6. A __________ route is the best path to reach a destination within the topology table.
  7. A routing protocol that supports route summarization must perform all except which of the following?
  8. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
  9. Which 1900 command enables port security?
  10. A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain…
  11. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  12. VLSM allows you to summarize __________ back to the class boundary.
  13. Which router command clears all of the static translations in the address translation table?
  14. OSPF supports a ________-layer hierarchical design.
  15. Which router command would take you back to a suspended telnet session?
  16. Which of the following trunking methods is/are proprietary to Cisco?
  17. With a crossover cable, which pins are crossed over?
  18. ________ topologies in NBMA environments do not have problems with split horizon.
  19. Private addressing is defined in RFC ______.
  20. When connecting a router to a PC, use a __________ cable.
  21. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  22. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  23. The default encapsulation on a synchronous serial interface is _________.
  24. A 1924 has _________ Ethernet interfaces.
  25. Which of the following is false concerning OSPF?
  26. When examining the IP routing table, an EIGRP route will be shown as what letter?
  27. 191.75.39.24 is a Class __________ address.
  28. Which of the following is a valid subnet mask value?
  29. When configuring a router-on-a-stick, the configuration is done on __________.
  30. Frames sent above the __________ limit will have their _________ bit set.