Home

A standard ice point temperature corresponds to the temperature of

A. Water at 0°C

B. Ice at 4°C

C. Solid and dry ice

D. Mixture of ice and water under equilibrium conditions

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The vertical and uniformly spaced lines on a psychrometric chart indicates
  2. In vapour compression cycle, the condition of refrigerant is very wet vapour
  3. The evolution of heat of solution takes place in ammonia absorption plant when
  4. The freezing point of R-12 is
  5. A condenser of refrigeration system rejects heat at the rate of 120 kW, while its compressor consumes…
  6. The sub-cooling in a refrigeration cycle
  7. In a refrigeration system, the expansion device is connected between the
  8. The boiling point of ________ is 10.5°C.
  9. The wet bulb temperature at 100% relative humidity is ________ dry bulb temperature.
  10. The vapour compression refrigerator employs the following cycle
  11. The coefficient of performance of a domestic refrigerator is ________ as compared to a domestic air-conditioner.
  12. The comfort conditions in air conditioning are at (where DBT = Dry bulb temperature, and RH = Relative…
  13. For ammonia refrigerating systems, the tubes of a shell and tube condenser are made of
  14. The power per tonne of refrigeration is
  15. Vapour compression refrigeration is somewhat like
  16. A pressure gauge on the discharge side of a refrigerant compressor reads too high. The reasons will…
  17. The alignment circle is marked on the psychrometric chart at
  18. The evaporator used in household refrigerators is
  19. A vapour absorption refrigerator uses __________ as a refrigerant.
  20. A refrigerant compressor is used to
  21. Refrigeration in aeroplanes usually employs the following refrigerant
  22. The undesirable property of a refrigerant is
  23. The leakage in a refrigeration system using ammonia is detected by
  24. The refrigerant used in small tonnage commercial machines (hermetically sealed units) is
  25. Freon group of refrigerants are
  26. The capillary tube, as an expansion device, is used in
  27. A standard ice point temperature corresponds to the temperature of
  28. In larger industrial and commercial reciprocating compression systems, refrigerant widely used is
  29. A thermostatic expansion valve in a refrigeration system
  30. For evaporators and condensers, for the given conditions, the logarithmic mean temperature difference…