A system of masses rotating in different parallel planes is in dynamic balance if the
Resultant force is equal to zero
Resultant couple is equal to zero
Resultant force and resultant couple are both equal to zero
Resultant force is numerically equal to the resultant couple, but neither of them need necessarily be zero
Also checkout these categories
Periodic Classification of Elements MCQ Reproductive System MCQ Machine Design MCQ Computer Fundamental MCQ Antonyms MCQ Thermodynamics MCQ Rearrangement Set 6 MCQ Chemical Engineering Plant Economics MCQ Rotational Motion MCQ Logarithm MCQ C# Programming MCQ Rearrangement Set 14 MCQ
- The centrifugal tension in belts
- TJIE horse power transmitted by a belt is dependent upon
- For high speed engines, the cam follower should move with
- In a reciprocating engine, usually __________ of the reciprocating masses are balanced.
- The height of a Watt's governor is
- Angle of ascent of cam is defined as the angle
- The pitching of a ship produces forces on the bearings which act __________ to the motion of the ship.
- The steering of a ship means
- The pressure angle of a cam depends upon
- Whirling speed of the shaft is the speed at which
- For the same lift and same angle of ascent, a smaller base circle will give
- Shaft revolving in a bearing is the following type of pair
- A thin circular disc is rolling with a uniform linear speed, along a straight path on a plane surface.…
- The centre of percussion is below the centre of gravity of the body and is at a distance equal to
- According to Kennedy's theorem, if three bodies move relatively to each other, their instantaneous centres…
- A Hartnell governor has its controlling force (Fc) given by Fc = ar + b, where r is the radius of rotation…
- In a cam drive with uniform velocity follower, the sharp corners of the displacement diagram are rounded…
- The D-slide valve is also known as
- The primary unbalanced force is maximum when the angle of inclination of the crank with the line of…
- Which of the following statement is correct for gears?
- With single Hooke's joint it is possible to connect two shafts, the axes of which have an angular misalignment…
- Critical damping is a function of
- A shaft carrying two rotors at its ends will have
- In a screw jack, the effort required to lift the load W is given by (where α = Helix angle, and…
- The velocity of the belt for maximum power is (where m = Mass of the belt in kg per metre length)
- Which of the following would constitute a link?
- A reed type tachometer use the principle of
- Which is the false statement about the properties of instantaneous centre?
- The frictional torque transmitted by a disc or plate clutch is same as that of
- In S.H.M., acceleration is proportional to