Related Questions
What is the correct answer?
4
When configuring your terminal emulation software for a console connection, set the flow control to __________.
What is the correct answer?
4
You are given the following addressing information: 172.17.16.255/23. What type of address is this?
What is the correct answer?
4
You execute the line console 0 command from Configuration mode. What will the router's prompt be?
C. Router(config-interface)#
What is the correct answer?
4
You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?
What is the correct answer?
4
The ___________ is the point where the carrier's responsibility ends and yours begins.
What is the correct answer?
4
Extended traceroute works from which mode?
D. User and Privilege EXEC
What is the correct answer?
4
Which interface type is used to connect to the serial interface of a router?
What is the correct answer?
4
_________ describe(s) users that can connect to a network from any location.
What is the correct answer?
4
You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
What is the correct answer?
4
You have a total of five routers. ________ circuits are required to fully mesh the network, where every router needs ___________ interfaces.
What is the correct answer?
4
A VTP server switch generates a summary advertisement every _________ minutes.
What is the correct answer?
4
You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
A. 00011011.10100010.00000100
B. 00000000.00000001.00000100
C. 00000001.10100010.00000100
D. 00000001.10100001.00000010
What is the correct answer?
4
_________ has a physical star topology but a logical ring topology.
What is the correct answer?
4
You are given a class C network, 192.168.1.0/24. You need one network with 120 hosts and three networks with 60 hosts. What subnet mask values would you use?
A. 255.255.255.128 and 255.255.255.192
What is the correct answer?
4
Which IGRP command allows unequal-cost load balancing?
What is the correct answer?
4
Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing protocol will your router use for this route?
What is the correct answer?
4
The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a router).
What is the correct answer?
4
The _______ program goes out and finds the IOS and loads it.
What is the correct answer?
4
The slot number of a 1900's Fast Ethernet uplink ports is ________.
D. No slot number is used
What is the correct answer?
4
Which router command would you use to view the configuration register value?
What is the correct answer?
4
You are given a class C network and you have four LAN segments with the following numbers of devices: 120, 60, and two with 30. What subnet mask values would you use to accommodate these segments?
What is the correct answer?
4
RIP generates routing updates every _________ seconds.
What is the correct answer?
4
If the port status LED on a 2950 is ________, there is a physical layer connection problem.
A. Flashing green and amber
What is the correct answer?
4
A __________ route is the best path to reach a destination within the topology table.
What is the correct answer?
4
When you have configured PPP on an interface and use the show interfaces command, what state indicates the successful negotiation of a network layer protocol?
What is the correct answer?
4
Private addressing is defined in RFC ______.
What is the correct answer?
4
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
What is the correct answer?
4
Which types of memory do not maintain their contents during a power-off state?
What is the correct answer?
4
___________ has both physical and logical ring topologies.
What is the correct answer?
4
What would you enter to see the last few commands you entered?