A _________ uses Gigabit Ethernet as a media type

Question

A _________ uses Gigabit Ethernet as a media type

A. WAN

B. LAN

C. MAN

D. LAN and MAN

Share this question with your friends

Show all WAN MCQ

Comment

You are at User EXEC mode and type the letter e. What message appears?

A. % Incomplete command.

B. % Ambiguous command:

C. % Unknown command or computer name

D. % Invalid input detected at '^'.

Discuss this answer

An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.

A. 120

B. 122

C. 130

D. 132

Discuss this answer

Which router command performs an overwrite process? (Choose all correct answers.)

A. copy running-config startup-config

B. copy startup-config running-config

C. copy tftp running-config

D. copy running-config tftp

Discuss this answer

You are given the following addressing information: 172.17.16.255/23. What type of address is this?

A. Network

B. Directed Broadcast

C. Host

Discuss this answer

________ topologies in NBMA environments do not have problems with split horizon.

A. Partially meshed

B. Fully meshed

C. Hub and spoke

D. Star

Discuss this answer

A routing protocol that supports route summarization must perform all except which of the following?

A. Carry the subnet mask with the network entry.

B. Make routing decisions based on the entire destination IP address.

C. Summarize entries so that the same lowest-order bits match.

D. None of these.

Discuss this answer

Which of the following is stored in ROM? (Choose all correct answers.)

A. POST

B. ROMMON

C. Configuration file

D. System recovery file

Discuss this answer

If you see a VC with an inactive status, this indicates ____________.

A. The connection between both Frame Relay DTEs is up and operational.

B. The connection between your Frame Relay DTE and DCE is up and operational, but there is something wrong with connection between your connected Frame Relay switch and the destination DTE.

C. You are not receiving any LMI messages from the Frame Relay switch.

Discuss this answer

You are given a class C network and you have four LAN segments with the following numbers of devices: 120, 60, and two with 30. What subnet mask values would you use to accommodate these segments?

A. /24, /25, and /26

B. /25, /26, and /27

C. /26, /27, and /28

D. None of these

Discuss this answer

Which interface type is used to connect to the serial interface of a router?

A. EIA/TIA-232

B. V.35

C. DB-60

D. X.21

Discuss this answer

The slot number of a 1900's Fast Ethernet uplink ports is ________.

A. 0

B. 1

C. 2

D. No slot number is used

Discuss this answer

When choosing a networking product, you should consider all of the following except _______.

A. Ease of installation and support

B. Product features and functions

C. Backplane capacity

D. Amount of memory

Discuss this answer

Which of the following is false concerning CHAP?

A. It sends an encrypted password.

B. It sends a challenge.

C. It is more secure than PAP.

D. It uses a three-way handshake.

Discuss this answer

What uses 64 Kbps of bandwidth?

A. PRI

B. BRI

C. DS1

D. DS0

Discuss this answer

What must you do to enable IP routing on your router? (Choose all of the correct answers.)

A. Enable the routing protocol.

B. Set clocking on all serial interfaces.

C. Assign IP addresses to your router's interfaces.

D. Assign the bandwidth parameter to your serial interfaces

Discuss this answer

When connecting a router to a PC, use a __________ cable.

A. Crossover

B. Straight-through

C. Rollover

Discuss this answer

Which control sequence moves the cursor to the end of the line?

A. CTRL-A

B. ctrl-p

C. ctrl-e

D. ctrl-z

Discuss this answer

Which router command clears all of the static translations in the address translation table?

A. erase ip nat translation *

B. clear ip nat translation *

C. clear ip nat translation all

D. None of these commands

Discuss this answer

The dialer map command contains all of the following parameters except __________.

A. Protocol name

B. Remote router name

C. Address of local router

D. Speed of the connection

Discuss this answer

Which of the following situations are best for DDR connections?

A. Primary WAN connection

B. A lot of constant traffic

C. Long phone calls

D. Backup connection

Discuss this answer

Which prompt indicates that you are at User EXEC mode?

A. >

B. #

C. %

D. @

Discuss this answer

_________ allows you to create this summarization: 10.0.0.0/7.

A. Subnetting

B. CDR

C. Supernetting

D. VLSM

Discuss this answer

EIGRP uses the _________ algorithm to update its routing table.

A. Bellman-Ford

B. Dijkstra

C. DUAL

D. Integrated

Discuss this answer

RIP generates routing updates every _________ seconds.

A. 15

B. 30

C. 60

D. 90

Discuss this answer

You have a total of five routers. circuits are required to fully mesh the network, where every router needs ___ interfaces.

A. 5, 5

B. 8, 4

C. 10, 5

D. 10, 4

Discuss this answer

If the port status LED on a 2950 is ________, there is a physical layer connection problem.

A. Flashing green and amber

B. Flashing green

C. Amber

D. Flashing amber

Discuss this answer

Which IGRP command allows unequal-cost load balancing?

A. variance

B. load

C. balance

D. network

Discuss this answer

Which type of traffic is not flooded?

A. Multicast

B. Known unicast

C. Broadcast

D. Unknown unicast

Discuss this answer

Private addressing is defined in RFC ______.

A. 1920

B. 1934

C. 1818

D. 1918

Discuss this answer

Which 1900 command enables port security?

A. port security

B. switchport security

C. port secure

D. switchport port-security

Discuss this answer

Accepted Answer

D. LAN and MAN

A _________ uses Gigabit Ethernet as a media type

Correct Answer :

Show all WAN MCQ

Related Questions

You are at User EXEC mode and type the letter e. What message appears?

An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.

Which router command performs an overwrite process? (Choose all correct answers.)

You are given the following addressing information: 172.17.16.255/23. What type of address is this?

________ topologies in NBMA environments do not have problems with split horizon.

A routing protocol that supports route summarization must perform all except which of the following?

Which of the following is stored in ROM? (Choose all correct answers.)

If you see a VC with an inactive status, this indicates ____________.

You are given a class C network and you have four LAN segments with the following numbers of devices: 120, 60, and two with 30. What subnet mask values would you use to accommodate these segments?

Which interface type is used to connect to the serial interface of a router?

The slot number of a 1900's Fast Ethernet uplink ports is ________.

When choosing a networking product, you should consider all of the following except _______.

Which of the following is false concerning CHAP?

What uses 64 Kbps of bandwidth?

What must you do to enable IP routing on your router? (Choose all of the correct answers.)

When connecting a router to a PC, use a __________ cable.

Which control sequence moves the cursor to the end of the line?

Which router command clears all of the static translations in the address translation table?

The dialer map command contains all of the following parameters except __________.

Which of the following situations are best for DDR connections?

Which prompt indicates that you are at User EXEC mode?

_________ allows you to create this summarization: 10.0.0.0/7.

EIGRP uses the _________ algorithm to update its routing table.

RIP generates routing updates every _________ seconds.

You have a total of five routers. circuits are required to fully mesh the network, where every router needs ___ interfaces.

If the port status LED on a 2950 is ________, there is a physical layer connection problem.

Which IGRP command allows unequal-cost load balancing?

Which type of traffic is not flooded?

Private addressing is defined in RFC ______.

Which 1900 command enables port security?

Also checkout

A _________ uses Gigabit Ethernet as a media type

Correct Answer :

Show all WAN MCQ

Related Questions

You are at User EXEC mode and type the letter e. What message appears?

An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.

Which router command performs an overwrite process? (Choose all correct answers.)

You are given the following addressing information: 172.17.16.255/23. What type of address is this?

________ topologies in NBMA environments do not have problems with split horizon.

A routing protocol that supports route summarization must perform all except which of the following?

Which of the following is stored in ROM? (Choose all correct answers.)

If you see a VC with an inactive status, this indicates ____________.

You are given a class C network and you have four LAN segments with the following numbers of devices: 120, 60, and two with 30. What subnet mask values would you use to accommodate these segments?

Which interface type is used to connect to the serial interface of a router?

The slot number of a 1900's Fast Ethernet uplink ports is ________.

When choosing a networking product, you should consider all of the following except _______.

Which of the following is false concerning CHAP?

What uses 64 Kbps of bandwidth?

What must you do to enable IP routing on your router? (Choose all of the correct answers.)

When connecting a router to a PC, use a __________ cable.

Which control sequence moves the cursor to the end of the line?

Which router command clears all of the static translations in the address translation table?

The dialer map command contains all of the following parameters except __________.

Which of the following situations are best for DDR connections?

Which prompt indicates that you are at User EXEC mode?

_________ allows you to create this summarization: 10.0.0.0/7.

EIGRP uses the _________ algorithm to update its routing table.

RIP generates routing updates every _________ seconds.

You have a total of five routers. ________ circuits are required to fully mesh the network, where every router needs ___________ interfaces.

If the port status LED on a 2950 is ________, there is a physical layer connection problem.

Which IGRP command allows unequal-cost load balancing?

Which type of traffic is not flooded?

Private addressing is defined in RFC ______.

Which 1900 command enables port security?

Also checkout

You have a total of five routers. circuits are required to fully mesh the network, where every router needs ___ interfaces.