Related Questions
What is the correct answer?
4
A VTP server switch generates a summary advertisement every _________ minutes.
What is the correct answer?
4
________ topologies in NBMA environments do not have problems with split horizon.
What is the correct answer?
4
The ___________ is the point where the carrier's responsibility ends and yours begins.
What is the correct answer?
4
Which of the following are not features of ACLs?
A. Restricting telnet access to a router
B. Prioritizing WAN traffic
C. Filtering traffic from the router
D. Triggering dialup phone calls
What is the correct answer?
4
Which would you use to move your cursor back one word?
What is the correct answer?
4
A ___________ is basically all of the components, hardware and software, involved
in connecting computers across small and large distances.
What is the correct answer?
4
The 1900 switch supports ________ VLANs.
What is the correct answer?
4
A _________ provides a high-speed infrastructure to move data between storage devices and file servers.
What is the correct answer?
4
If you wanted a list of parameters for the show command, you would type ________.
What is the correct answer?
4
A routing protocol that supports route summarization must perform all except which of the following?
A. Carry the subnet mask with the network entry.
B. Make routing decisions based on the entire destination IP address.
C. Summarize entries so that the same lowest-order bits match.
What is the correct answer?
4
A _________ routes between different autonomous systems.
What is the correct answer?
4
You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
What is the correct answer?
4
Which of the following is true concerning ISL?
A. It is supported on both the 1900 and 2950 switches.
B. It adds a 26-byte trailer and 4-byte header.
C. Tagging is done in software.
D. The original Ethernet frame is not modified.
What is the correct answer?
4
Which interface type is used to connect to the serial interface of a router?
What is the correct answer?
4
The _______ program goes out and finds the IOS and loads it.
What is the correct answer?
4
Which command assigns a default gateway to the 2950 switch?
A. (config)# default-gateway
B. (config-if)# default-gateway
C. (config-if)# ip default-gateway
D. (config)# ip default-gateway
What is the correct answer?
4
You are given a class C network and you have four LAN segments with the following numbers of devices: 120, 60, and two with 30. What subnet mask values would you use to accommodate these segments?
What is the correct answer?
4
Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________ seconds.
What is the correct answer?
4
A ________ topology describes how devices communicate with each other.
What is the correct answer?
4
What would you use to prevent a packet from traveling around a routing loop forever?
What is the correct answer?
4
RIP has a hold-down period of ____________ seconds.
What is the correct answer?
4
Which of the following is true concerning bridges?
A. They switch frames in hardware.
B. They support half- and full-duplexing.
C. They support one collision domain for the entire bridge.
D. They do only store-and-forward switching.
What is the correct answer?
4
_________ describe(s) users that can connect to a network from any location.
What is the correct answer?
4
What uses 64 Kbps of bandwidth?
What is the correct answer?
4
A Class A address has _________ host bits.
What is the correct answer?
4
You are in Interface Subconfiguration mode and want to completely return to Privilege EXEC mode. What would you enter? (Choose all correct answers.)
What is the correct answer?
4
The address of a Frame Relay VC is called a ___________.
A. Data link layer connection identifier
B. Data layer connection index
C. Data link connection index
D. Data link connection identifier
What is the correct answer?
4
You are given the following addressing information: 172.17.16.255/23. What type of address is this?
What is the correct answer?
4
Which of the following is the most expensive type of WAN connection?
A. Dedicated circuit connection
B. Circuit-switched connection
C. Packet-switched connection
What is the correct answer?
4
When connecting a router to a PC, use a __________ cable.