Home

An _____________ is a public IP address associated with an inside device.

A. Inside global IP address

B. Inside local IP address

C. Outside global IP address

D. Outside local IP address

You can do it
  1. Which of the following is false concerning VLANs?
  2. What would you use to prevent a packet from traveling around a routing loop forever?
  3. Which would you use to move your cursor back one word?
  4. You are given the following addressing information: 172.17.16.255/23. What type of address is this?
  5. You have this binary value: 11000001. This equates to _____ in decimal.
  6. Which of the following trunking methods is/are proprietary to Cisco?
  7. Which router command specifies the ISDN switch the router is connected to?
  8. Which command activates an IP ACL on a router's interface?
  9. You are given a Class B network with a subnet mask of 255.255.255.192. How many hostaddresses are there…
  10. Which of the following is true concerning RIPv2?
  11. Which 2950 command assigns a VLAN to an interface?
  12. Which router-on-a-stick command defines the VLAN for the interface?
  13. Frames sent above the __________ limit will have their _________ bit set.
  14. Which of the following situations are best for DDR connections?
  15. Which protocol supports VLSM?
  16. The OSPF process ID is __________.
  17. When choosing a networking product, you should consider all of the following except _______.
  18. A VTP server switch generates a summary advertisement every _________ minutes.
  19. _________ has a physical star topology but a logical ring topology.
  20. ________ topologies in NBMA environments do not have problems with split horizon.
  21. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  22. When choosing a dynamic routing protocol, which of the following should not be considered?
  23. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  24. During the learning function, the switch places addresses and ports in a(n) _________ table.
  25. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  26. What router command saves the active configuration to NVRAM?
  27. Which Frame Relay command is used to manually resolve addresses?
  28. A _________ connects two or more LANs in the same geographic area.
  29. A ___________ is similar to a telephone circuit-switched connection.
  30. The _______ program goes out and finds the IOS and loads it.