Related Questions
What is the correct answer?
4
This is the plane upon which the top view is projected:
What is the correct answer?
4
A partial auxiliary view usually shows only features on the ________ of the inclined line and not any projection of other planes.
What is the correct answer?
4
In oblique sketches, the most commonly used angles for receding lines are:
What is the correct answer?
4
This process recognizes the inherent interrelationships between design and manufacturing:
A. Design for manufacture
B. Design for manufacture and assembly
C. Design for concurrent engineering
What is the correct answer?
4
Placement of dimensions on a drawing is controlled by ________.
C. Corporate drafting standards
What is the correct answer?
4
Some of the standard Auto-CAD text styles used in architectural drawings includes ________.
What is the correct answer?
4
This is the bottom surface joining the sides of two adjacent threads:
What is the correct answer?
4
This is the theoretically exact size from which limits of size are determined:
What is the correct answer?
4
A civil engineer working on a bridge design would probably rely on his ________ scale for checking printed drawings.
What is the correct answer?
4
In the mechanical design process the first step is to ________.
B. Prepare rough sketches
What is the correct answer?
4
This material is used in masonry construction, most commonly for ornamental facing:
What is the correct answer?
4
The building construction industry relies on sets of ________ drawings to construct homes and commercial buildings.
What is the correct answer?
4
Oblique sections are useful to show this:
A. Foreshortened features
What is the correct answer?
4
Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:
What is the correct answer?
4
EDM is the acronym for:
A. Enterprise data management
B. Engineering drawing management
C. Enterprise drawing manipulation
D. Engineering data manipulation
What is the correct answer?
4
A line with a tapering width can be easily created by using the __________ tool.
What is the correct answer?
4
The most common geometric form used in gears today is this:
What is the correct answer?
4
When creating a block the drafter needs to pay particular attention to selecting a base point because it determines the ________.
What is the correct answer?
4
In order to set drawing limits for a C size architectural drawing the drafter should set the limits to ________.
What is the correct answer?
4
Some of the common terms used to describe technical drawing include:
What is the correct answer?
4
The second line of dimensions out from the plan generally includes ________.
A. Centers of doors and windows
B. The distances between outside walls and interior walls
C. The measurement from the outside of the brick to the inside of the exterior wall
D. The measurement from one outside corner to the opposite outside corner
What is the correct answer?
4
Which of the following is one of the basic types of welded joints:
What is the correct answer?
4
This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:
What is the correct answer?
4
When creating your own blocks it is important to avoid drawing any portion of the block in the ________ layer.
What is the correct answer?
4
These are special installations of stone or concrete marking the locations of points accurately determined by precise surveying:
What is the correct answer?
4
These maps are used in planning installations of trees, shrubbery, drives, and other garden features:
What is the correct answer?
4
Baseline dimensions are referenced from a common geometric feature known as a ________.
What is the correct answer?
4
The thread note for a typical bolt will include the ________.
A. Major diameter of the thread
What is the correct answer?
4
Referring to the fractional inches to decimal inches to millimetre conversion chart on page 55 what is the equivalent mm measurement of 3/16 inch.
What is the correct answer?
4
This is a solid shape that fits inside the mold and forms a hole in a cooled cast metal or molten plastic object: