Home

Annex A is which LMI standard?

A. Cisco

B. ITU-T Q.933

C. ANSI

Related Questions

  1. Which is true concerning a port in a listening state? (Choose all correct answers.).
  2. A Class A address has _________ host bits.
  3. PPP can do all of the following except ___________.
  4. The 1900 switch supports ________ VLANs.
  5. You are given the following addressing information: 172.17.16.255/23. What type of address is this?
  6. Which controller command specifies how ones and zeros are represented on a digital circuit?
  7. A VTP server switch generates a summary advertisement every _________ minutes.
  8. A routing protocol that supports route summarization must perform all except which of the following?
  9. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  10. Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________…
  11. Which router command would you use to test only layer-3 connectivity?
  12. EIGRP will route for ___________.
  13. OSPF supports a ________-layer hierarchical design.
  14. What uses 64 Kbps of bandwidth?
  15. Which of the following reasons might you need to use address translation?
  16. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  17. The ___________ converts an ISDN four-wire connection to a two-wire connection.
  18. OSPF uses __________ as a metric.
  19. VLSM allows a network segment to have more than one subnet mask.
  20. Which 2950 command assigns a VLAN to an interface?
  21. Which of the following is true concerning ISL?
  22. Which of the following commands belongs on the physical interface when using dialer profiles?
  23. Which interface type is used to connect to the serial interface of a router?
  24. Which of the following is false concerning OSPF?
  25. Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing…
  26. What subnet mask would you use to set up a default route?
  27. If you wanted a list of parameters for the show command, you would type ________.
  28. _________ describe(s) users that can connect to a network from any location.
  29. How many steps do LCP and NCP go through when setting up a connection?
  30. Which types of memory do not maintain their contents during a power-off state?

Please do not use chat terms. Example: avoid using "grt" instead of "great".