Architectural dimensioning is usually done in ________.

Related Questions

1. The most common geometric form used in gears today is this:
2. A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
3. Which of the following is one of the basic types of welded joints:
4. This type of projection is when projectors are parallel to each other, but is at an angle other than…
5. This is a rounded exterior blend between surfaces:
6. The edges of a cube in isometric projection make angles of this many degrees with each other:
7. This is the most common application for developments and intersections:
8. Generally, the units used on an architectural drawing are set to ________.
9. Perspective drawings are classified according to their number of these features:
10. The thread note for a typical bolt will include the ________.
11. The Conceptual Visual Style tool is located on the ________ toolbar.
12. Lines of an isometric drawing that are not parallel to the isometric axes are called this:
13. A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line…
14. This is the plane upon which the top view is projected:
15. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
16. The organized and orderly approach to solving problems is known as the:
17. Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point…
18. This allows the performance of structures to be analyzed and tested efficiently, accurately, and quickly:
19. The Free Orbit tool is found on the ________ toolbar.
20. This is the range of digital or hard copy documents that specify the physical function requirements…
21. Inserting blocks into a drawing file usually requires exacting placement. The drafter should insure…
22. When lettering a CAD drawing, for clarity you should limit the number of fonts to:
23. This is a line terminated by arrowheads, indicating the direction and extent of a dimension:
24. A fillet is a rounded surface on the ________ corner of a part.
25. In an exploded assembly drawing it is customary for the drafter to use a ________ line to illustrate…
26. Architectural dimensioning standards allow for the placement of dimensions inside the floor plan. These…
27. This type of surface is tipped to all principal planes of projection and does not appear true size in…
28. This is a systematic approach that integrates the design and manufacture of products with the goal of…
29. In architectural drawing ________ are often used to illustrate and detail structural components.
30. This is the total amount that the feature on the actual part is allowed to vary from what is specified…

Also checkout these categories