Home

Broaching tools are usually made of

A. Cermets

B. High speed steel

C. Tungsten carbide

D. Stellite

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Moist climate is the most favourable factor in the site selection far a
  2. The swift cup test evaluates the following property of a sheet metal.
  3. Electrostatic separation of minerals from each other is based on their differences in the following…
  4. Thermit welding uses the following energy source.
  5. Mild steel has __________ crystal lattice structure.
  6. Which of the following commonly used condenser tube materials has the lowest thermal conductivity?
  7. Which of the following emissions in the exhaust gas of an I.C. engine causes the formation of photochemical…
  8. Often earing defects are found during deep drawing operation, because the
  9. Air standard Otto cycle is more efficient than the diesel cycle for the same
  10. Minimum safe distance between two liquid fuel storage tanks is equal to (where, H = height of the tank)
  11. Maraging steels derive their strength from the following mechanism:
  12. Upto the critical radius of insulation, added insulation, will
  13. Pick out the wrong statement.
  14. Which of the following is not an explosive?
  15. Out of the following, the joint produced by __________ has the lowest strength.
  16. Hardening of steel is not possible, unless it is heated __________ critical point.
  17. The Al2O3 content of cryolite in Hall- Heroult cell is maintained between __________ percent.
  18. __________ number determines whether the fluid flow in an open channel is supercritical, critical or…
  19. The burnout heat flux in the nucleate boiling regime is not a function of the
  20. Tempering of a material does not improve its
  21. Thermal conductivity of a material does not depend upon its
  22. Half life of a radioactive isotope corresponds to the time required for half of the __________ to decay.
  23. The excess air required for the combustion of pulverised coal is of the order of about __________ percent.
  24. Carbon is present in the form of __________ in grey cast iron.
  25. A solid aluminium ball, when quenched in a water bath maintained at 40°C, cools down from 550°C…
  26. Which of the following test is used for distinguishing among dry oils, semi-drying oils and non drying…
  27. Hot dipping process is used for coating a low melting point metal (e.g. Pb, Sn, Zn) on iron, steel &…
  28. The atmospheric temperature during melting of ice/snow (in the atmosphere)
  29. A solar cell converts the sunlight directly into __________ energy.
  30. Fibrous fracture is normally encountered in the __________ materials.