Home

Carnot cycle consists of

A. Two constant volume and two isentropic processes

B. Two isothermal and two isentropic processes

C. Two constant pressure and two isentropic processes

D. One constant volume, one constant pressure and two isentropic processes

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. A close cycle gas turbine gives __________ efficiency as compared to an open cycle gas turbine.
  2. When it is indicated that a member is elastic, it means that when force is applied, it will
  3. Which of the following is the correct statement of the second law of thermodynamics?
  4. A series of operations, which takes place in a certain order and restore the initial conditions at the…
  5. During a tensile test on a specimen of 1 cm cross-section, maximum load observed was 8 tonnes and area…
  6. In open cycle gas turbine plants
  7. A key is subjected to side pressure as well at shearing forces. These pressures are called
  8. An adiabatic process is one in which
  9. The general law for the expansion or compression of gases, is
  10. A column of length (l) with both ends fixed may be considered as equivalent to a column of length __________…
  11. In a belt drive, the pulley diameter is doubled, the belt tension and pulley width remaining same. The…
  12. The total strain energy stored in a body is termed a
  13. A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa…
  14. Which of the following statement is wrong?
  15. The atomic mass of nitrogen is __________ oxygen.
  16. Slenderness of a column is zero when
  17. The increase in entropy of a system represents
  18. The maximum diameter of the hole that can be punched from a plate of maximum shear stress 1/4th of its…
  19. A process of heating crude oil to a high temperature under a very high pressure to increase the yield…
  20. Mond gas is obtained by
  21. A simply supported beam with a gradually varying load from zero at B and w per unit length at A is shown…
  22. The sum of internal energy (U) and the product of pressure and volume (p.v) is known as
  23. Which of the following gas has the highest calorific value?
  24. Which is the incorrect statement about Carnot cycle?
  25. A pressure vessel is said to be a thick shell, when
  26. The property of a material by virtue of which it can be beaten or rolled into plates is called
  27. A closely-coiled helical spring is cut into two halves. The stiffness of the resulting spring will be
  28. Young's modulus is defined as the ratio of
  29. Those substances which have so far not been resolved by any means into other substances of simpler form…
  30. The limit of eccentricity for no tensile conditions for a column of circular section of diameter (D)…