Choose the following that a standard IP ACL can match on.

A. Destination address

B. IP protocol

C. IP protocol information

D. None of the above

You can do it
  1. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  2. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  3. A _________ provides a high-speed infrastructure to move data between storage devices and file servers.
  4. A ________ topology describes how devices communicate with each other.
  5. IGRP generates an update every ___________ seconds.
  6. What would you use to prevent a packet from traveling around a routing loop forever?
  7. A __________ route is the best path to reach a destination within the topology table.
  8. To recall a previous command, which of the following would you use?
  9. Which router command would you use to test only layer-3 connectivity?
  10. VLSM allows you to summarize __________ back to the class boundary.
  11. When connecting a switch to a router, use a ___________ cable.
  12. You are given a Class B network with a subnet mask of How many hostaddresses are there…
  13. EIGRP generates hellos every _________ seconds on LAN segments.
  14. The function of the MODE button is to __________.
  15. Which of the following is stored in ROM? (Choose all correct answers.)
  16. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  17. You execute the line console 0 command from Configuration mode. What will the router's prompt be?
  18. Extended IP ACLs should be placed as close to the ____________ device as possible.
  19. Which type of traffic is not flooded?
  20. If you wanted a list of parameters for the show command, you would type ________.
  21. Distance vector protocols use ___________ to disseminate routing information.
  22. What subnet mask would you use to set up a default route?
  23. OSPF hellos are sent every __________ seconds on a multi-access medium.
  24. Which router command performs an overwrite process? (Choose all correct answers.)
  25. You are given a Class C network with 25 bits of networking. How many subnets do you have?
  26. What would you enter to see the last few commands you entered?
  27. What command creates a DHCP address pool on a router?
  28. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  29. ___________ defines LAPD, which is responsible for the data-link layer connection between the router…
  30. A ___________ is similar to a telephone circuit-switched connection.