Home

Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:

A. Circular

B. Elliptical

C. Lengthened

D. Angular

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection…
  2. Most architectural firms and mechanical design companies utilize different categories of blocks. These…
  3. An architect often relies on a ________ to complete the set of technical drawings used in the design…
  4. The ________ dimension tool will place the length of an angled line.
  5. The primary unit of measurement for engineering drawings and design in the mechanical industries is…
  6. In the mechanical design process the first step is to ________.
  7. By using a ________ section of a cylindrical mechanical part the drafter should be able to show only…
  8. This type of weld is the most common in structural steel fabrication:
  9. These types of projectors converge at a vanishing point:
  10. The building construction industry relies on sets of ________ drawings to construct homes and commercial…
  11. This is the bottom surface joining the sides of two adjacent threads:
  12. Lines of an isometric drawing that are not parallel to the isometric axes are called this:
  13. The edges of a cube in isometric projection make angles of this many degrees with each other:
  14. In this type of view, the cutting plane line indicates both the location of the cutting plane and the…
  15. Several of the tools used in traditional drafting include the following:
  16. This type of drawing shows two lines representing the pipe diameter:
  17. This is a rounded exterior blend between surfaces:
  18. This type of circuit is a semiconductor wafer or chip:
  19. An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
  20. Architectural drafters generally prefer to use ________ drawings to help illustrate 3-dimensional views…
  21. A secondary auxiliary view is a projection off of the ________.
  22. In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
  23. This process recognizes the inherent interrelationships between design and manufacturing:
  24. Architectural dimensioning is usually done in ________.
  25. In this type of section, one quarter of the object is removed:
  26. Welding drawings are a special type of this kind of drawing:
  27. In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
  28. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
  29. A typical set of mechanical working drawings includes ________.
  30. In offset sections, offsets or bends in the cutting plane are all: