Home

Dephosphorization of molten pig iron is favoured by

A. Oxidising and basic slag

B. Reducing and basic slag

C. High activity co-efficient of phosphorous in metal

D. Oxidising and neutral slag

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. In the X-ray radiography technique, the tube voltage for thicker plates as compared to thin plates,…
  2. Breakeven point represents the condition, when the company runs under no profit no loss condition. In…
  3. Heating of ferromagnetic materials to a temperature above Curie temperature makes it
  4. The excess air required for the combustion of pulverised coal is of the order of about __________ percent.
  5. Hydrogen in liquid steels is dissolved
  6. All the atoms of the world comprise of electrons, proton & neutron except that of __________ atom in…
  7. Unit of viscosity in CGS system is
  8. The heat of neutralisation remains constant, when there is a reaction between dilute solutions of strong
  9. Fatigue limit improvement by over stressing the metal by successively increasing the load is called…
  10. Pick out the wrong statement.
  11. The most suitable material of construction for a sewer to carry sewage under high pressure is
  12. In case of a, centrifugal pump, the ratio h1/h2 is termed as the __________ efficiency (where, h1 =…
  13. A thin, flat & square plate measuring 2 m × 2 m is freely hanging in ambient air at 25°C.…
  14. Reduction in the grain size reduces the __________ of the material.
  15. Difference at any instant between the value of the controlled variable and the set point is called the
  16. Addition of __________ to steel does not impart hardness.
  17. Coating thickness in case of galvanising of steel sheet generally corresponds to the deposition of __________…
  18. Out of the following substances, one ton of __________ will store the maximum heat for a rise of 30°C…
  19. Silicon in steel
  20. The cooling rate required to freeze 1 ton of water at 0°C into ice at 0°C in 24 hours is __________…
  21. The ability of tool steel to resist softening at high temperatures is termed as __________ hardness.
  22. Earing is a defect found in steels after the following metal working operation.
  23. 'Cryogenics' is concerned with the generation & use of low temperature in the range of
  24. Air-petrol ratio in an automotive petrol engine is around
  25. Which of the following approaches the ideal gas behaviour most closely?
  26. Gas turbine normally employs a constant __________ cycle.
  27. For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other…
  28. If the head is doubled in & centrifugal pump, the power required will increase in the ratio of
  29. Fibre glass is a composite material of
  30. Shaft/rotor speed is most accurately measured by a