Home

EIGRP generates hellos every _________ seconds on LAN segments.

A. 5

B. 10

C. 15

D. 30

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. IOS images can be loaded from all the following except:
  2. Which of the following commands belongs on the physical interface when using dialer profiles?
  3. How many steps do LCP and NCP go through when setting up a connection?
  4. When using the show interfaces command, which Frame Relay information can you not see?
  5. A _________ is a network that provides a secure connection from a company to other business partners.
  6. Which of the following reasons might you need to use address translation?
  7. When connecting a switch to a router, use a ___________ cable.
  8. Which router command clears all of the static translations in the address translation table?
  9. You are at User EXEC mode and type the letter e. What message appears?
  10. RIP supports load balancing for up to __________ ___________ paths.
  11. You are given a class C network and you have four LAN segments with the following numbers of devices:…
  12. RIP has a hold-down period of ____________ seconds.
  13. Which of the following is false concerning CHAP?
  14. Private addressing is defined in RFC ______.
  15. If the 2950's RPS is ________, the external power supply is supplying power.
  16. When setting up an RJ-45 console connection, you need a RJ-45-to-DB-9 __________ adapter to attach to…
  17. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  18. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  19. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  20. What command assigns a User EXEC password to a 2950 switch?
  21. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  22. Which command assigns a default gateway to the 2950 switch?
  23. If the port status LED on a 2950 is ________, there is a physical layer connection problem.
  24. ___________ defines LAPD, which is responsible for the data-link layer connection between the router…
  25. Which of the following is true concerning full-duplexing?
  26. Which 2950 command assigns a VLAN to an interface?
  27. BPDU stands for ____________.
  28. Which of the following is a valid subnet mask value?
  29. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  30. When examining the IP routing table, an EIGRP route will be shown as what letter?