EIGRP will route for ___________.

Question

EIGRP will route for ___________.

A. IP

B. IP and IPX

C. IP and AppleTalk

D. IP, IPX, and AppleTalk

Share this question with your friends

Show all WAN MCQ

Comment

When choosing a networking product, you should consider all of the following except _______.

A. Ease of installation and support

B. Product features and functions

C. Backplane capacity

D. Amount of memory

Discuss this answer

Which of the following are not features of ACLs?

A. Restricting telnet access to a router

B. Prioritizing WAN traffic

C. Filtering traffic from the router

D. Triggering dialup phone calls

Discuss this answer

A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.

A. WAN

B. LAN

C. MAN

D. LAN and MAN

Discuss this answer

With a crossover cable, which pins are crossed over?

A. 1 and 2, 3 and 6

B. 1 and 3, 2 and 6

C. 1 and 4, 2 and 6

D. 1 and 3, 4 and 6

Discuss this answer

You execute the line console 0 command from Configuration mode. What will the router's prompt be?

A. Router(config)#

B. Router(config-line)#

C. Router(config-interface)#

D. Router#(config-if)

Discuss this answer

What command activates the IP routing process?

A. router

B. enable

C. network

D. no shutdown

Discuss this answer

Which of the following is stored in ROM? (Choose all correct answers.)

A. POST

B. ROMMON

C. Configuration file

D. System recovery file

Discuss this answer

When using the show interfaces command, which Frame Relay information can you not see?

A. The DLCI number used for LMI

B. The number of LMIs sent and received

C. Statuses of PVCs

D. The LMI type

Discuss this answer

RIP supports load balancing for up to _ paths.

A. Six, unequal-cost

B. Four, unequal-cost

C. Four, equal-cost

D. Six, equal-cost

Discuss this answer

EIGRP generates hellos every _________ seconds on LAN segments.

A. 5

B. 10

C. 15

D. 30

Discuss this answer

Which of the following is false concerning CHAP?

A. It sends an encrypted password.

B. It sends a challenge.

C. It is more secure than PAP.

D. It uses a three-way handshake.

Discuss this answer

Which 2950 command enables trunking?

A. switchport mode trunk

B. trunking on

C. trunking enable

D. switchport trunk on

Discuss this answer

A _________ routes between different autonomous systems.

A. BPG

B. EGP

C. IPP

D. IGP

Discuss this answer

Annex A is which LMI standard?

A. Cisco

B. ITU-T Q.933

C. ANSI

Discuss this answer

Which router command performs an overwrite process? (Choose all correct answers.)

A. copy running-config startup-config

B. copy startup-config running-config

C. copy tftp running-config

D. copy running-config tftp

Discuss this answer

If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.

A. Green

B. Off

C. Amber

D. None of these

Discuss this answer

A ___________ is basically all of the components, hardware and software, involved
in connecting computers across small and large distances.

A. LAN

B. WAN

C. Network

D. SAN

Discuss this answer

_________ defines how the Frame Relay DTE and DCE interact with each other.

A. DLCI

B. CIR

C. LMI

D. PMI

Discuss this answer

Which router-on-a-stick command defines the VLAN for the interface?

A. vlan

B. encapsulation

C. trunk

D. frame-type

Discuss this answer

________ topologies in NBMA environments do not have problems with split horizon.

A. Partially meshed

B. Fully meshed

C. Hub and spoke

D. Star

Discuss this answer

RIP generates routing updates every _________ seconds.

A. 15

B. 30

C. 60

D. 90

Discuss this answer

You are given the following addressing information: 192.168.37.192/25. What type of address is this?

A. Network

B. Directed Broadcast

C. Host

Discuss this answer

Frames sent above the __ limit will have their _ bit set.

A. CIR, DE

B. BC, DE

C. BC, FECN

D. CIR, FECN

Discuss this answer

You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?

A. 4

B. 6

C. 8

D. 14

Discuss this answer

The slot number of a 1900's Fast Ethernet uplink ports is ________.

A. 0

B. 1

C. 2

D. No slot number is used

Discuss this answer

_________ negotiates the data link and network layer protocols that will traverse a PPP connection.

A. LCP

B. NCP

C. CDP

D. PAP

Discuss this answer

Enter the wildcard mask value to match on every bit position in an address: _________.

A. 255.0.0.0

B. 0.0.0.0

C. 255.255.255.255

D. 255.255.0.0

Discuss this answer

The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a router).

A. Demarcation point

B. Carrier switch

C. Local loop

D. CPE

Discuss this answer

There are _________ actions a router can take when there is a match on an ACL statement

A. 1

B. 2

C. 3

D. 4

Discuss this answer

You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks with 30 hosts. What are the subnet mask values you could use?

A. 255.255.255.128 and 255.255.255.192

B. 255.255.255.224 and 255.255.255.240

C. 255.255.255.192 and 255.255.255.224

D. None of these

Discuss this answer

Accepted Answer

D. IP, IPX, and AppleTalk

EIGRP will route for ___________.

Correct Answer :

Show all WAN MCQ

Related Questions

When choosing a networking product, you should consider all of the following except _______.

Which of the following are not features of ACLs?

A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.

With a crossover cable, which pins are crossed over?

You execute the line console 0 command from Configuration mode. What will the router's prompt be?

What command activates the IP routing process?

Which of the following is stored in ROM? (Choose all correct answers.)

When using the show interfaces command, which Frame Relay information can you not see?

RIP supports load balancing for up to _ paths.

EIGRP generates hellos every _________ seconds on LAN segments.

Which of the following is false concerning CHAP?

Which 2950 command enables trunking?

A _________ routes between different autonomous systems.

Annex A is which LMI standard?

Which router command performs an overwrite process? (Choose all correct answers.)

If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.

A ___________ is basically all of the components, hardware and software, involved
in connecting computers across small and large distances.

_________ defines how the Frame Relay DTE and DCE interact with each other.

Which router-on-a-stick command defines the VLAN for the interface?

________ topologies in NBMA environments do not have problems with split horizon.

RIP generates routing updates every _________ seconds.

You are given the following addressing information: 192.168.37.192/25. What type of address is this?

Frames sent above the __ limit will have their _ bit set.

You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?

The slot number of a 1900's Fast Ethernet uplink ports is ________.

_________ negotiates the data link and network layer protocols that will traverse a PPP connection.

Enter the wildcard mask value to match on every bit position in an address: _________.

The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a router).

There are _________ actions a router can take when there is a match on an ACL statement

You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks with 30 hosts. What are the subnet mask values you could use?

Also checkout

EIGRP will route for ___________.

Correct Answer :

Show all WAN MCQ

Related Questions

When choosing a networking product, you should consider all of the following except _______.

Which of the following are not features of ACLs?

A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.

With a crossover cable, which pins are crossed over?

You execute the line console 0 command from Configuration mode. What will the router's prompt be?

What command activates the IP routing process?

Which of the following is stored in ROM? (Choose all correct answers.)

When using the show interfaces command, which Frame Relay information can you not see?

RIP supports load balancing for up to __________ ___________ paths.

EIGRP generates hellos every _________ seconds on LAN segments.

Which of the following is false concerning CHAP?

Which 2950 command enables trunking?

A _________ routes between different autonomous systems.

Annex A is which LMI standard?

Which router command performs an overwrite process? (Choose all correct answers.)

If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.

A ___________ is basically all of the components, hardware and software, involvedin connecting computers across small and large distances.

_________ defines how the Frame Relay DTE and DCE interact with each other.

Which router-on-a-stick command defines the VLAN for the interface?

________ topologies in NBMA environments do not have problems with split horizon.

RIP generates routing updates every _________ seconds.

You are given the following addressing information: 192.168.37.192/25. What type of address is this?

Frames sent above the __________ limit will have their _________ bit set.

You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?

The slot number of a 1900's Fast Ethernet uplink ports is ________.

_________ negotiates the data link and network layer protocols that will traverse a PPP connection.

Enter the wildcard mask value to match on every bit position in an address: _________.

The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a router).

There are _________ actions a router can take when there is a match on an ACL statement

You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks with 30 hosts. What are the subnet mask values you could use?

Also checkout

RIP supports load balancing for up to _ paths.

A ___________ is basically all of the components, hardware and software, involved
in connecting computers across small and large distances.

Frames sent above the __ limit will have their _ bit set.