Home

Ethernet ___________ has/have both a physical and logical bus topology.

A. 10BaseT

B. 10Base2 and 10Base5

C. 10BaseT and 10Base2

D. 10BaseT, 10Base2, and 10Base5

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  2. ________ topologies in NBMA environments do not have problems with split horizon.
  3. If you wanted a list of parameters for the show command, you would type ________.
  4. When configuring your terminal emulation software for a console connection, set the flow control to…
  5. Which of the following is a Network layer protocol for the TCP/IP protocol stack?
  6. The OSPF process ID is __________.
  7. IOS images can be loaded from all the following except:
  8. Which VTP mode(s) will propagate VTP messages?
  9. Which is true concerning a port in a listening state? (Choose all correct answers.).
  10. RIP has a maximum hop count of ____________ hops.
  11. You are given this address space: 172.16.5.0/25. You need one network with 64 hosts and two with 30…
  12. RIP generates routing updates every _________ seconds.
  13. EIGRP generates hellos every _________ seconds on LAN segments.
  14. A ___________ is similar to a telephone circuit-switched connection.
  15. When connecting a switch to a router, use a ___________ cable.
  16. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  17. The _______ program goes out and finds the IOS and loads it.
  18. Which router command clears all of the static translations in the address translation table?
  19. If the 1900 SYSTEM LED is _________, a system POST test has failed.
  20. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
  21. The ___________ converts an ISDN four-wire connection to a two-wire connection.
  22. _________ is/are a routed protocol.
  23. If the 2950's RPS is ________, the external power supply is supplying power.
  24. When choosing a WAN solution, consider all of the following except __________.
  25. A Class A address has _________ host bits.
  26. Which command takes you from Privilege EXEC mode to User EXEC mode?
  27. You are given a Class C network, 192.168.1.0/24. You need one network with 120 hostsand two networks…
  28. On the 1900 switch, how do you enter User EXEC mode?
  29. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  30. The 1900 switch supports ________ VLANs.