For a series circuita the higher the quality factor
The greater the bandwidth
The narrower the passband
The broader the resonance curve
The wider the passband
Correct Answer :
B. The narrower the passband
Related Questions
In an inductive coila the rate of rise of current is maximum
Near the final maximum value of current
At midvalue of current
At half-power points
After one time constant
Which of the following capacitors are used only in dc circuits?
Mica
Ceramic
Mylar
Electrolytic
The temperature-resistance coefficient of pure gold is
The distance between the capacitor plates increases two timesa then its capacitance
Increases two times
Increases four times
Decreases two times
Decreases four times
For a series circuita the higher the quality factor
The greater the bandwidth
The narrower the passband
The broader the resonance curve
The wider the passband
A series RLCcircuit has a ______ power factor at its half-power points
Unity
Leading
Lagging
Either B or C
In a complex resistance-reactance planea XLis represented
By an axis opposite the R axis
By an axis perpendicular to the XC axis
By an axis opposite the XCaxis
By an axis parallel to the R axis
What value of R is needed with a 0.05 F Cfor an RCtime constant of 0.02 s?
400 M
400 G
400 k
If two equal resistances connected in series across a certain supply are now connected in parallel across the same supplya the power produced will be _____ that of series connection
One-half
One-fourth
Two times
Four times
The ratio between the reactive power and the apparent power of an ac load is called
Quality factor
Power factor
Power ratio
Reactive power
What maximum voltage can be applied across the capacitor of time?
Working voltage
Surge voltage
Stray voltage
Peak voltage
The reactance curve is a plot of frequency versus _____ for a series RLCcircuit
Current
Voltage
Gain
Impedance
An inductor carries 2 A dc. If its inductance is 100 Ha then what is its inductive reactance?
Zero
1.3 k
A rheostat is a form of
Variable resistor
Variable capacitor
Potentiometer
Thermocouple
What is the specific resistance of a pure silicon?
55 -mm
55 -m
55 -cm
55 k -m
What is the most convenient way of achieving large capacitance?
By using multiplate construction
By using air as dielectric
By decreasing distance between plates
By using dielectric of low permittivity
The reason why electrical appliances are connected in parallel.
It is a simple circuit
This makes the operation of appliances independent with each other
This results in reduced power consumption
All of the above
The charge in the capacitor is stored at the
Terminals
Plates
Dielectric
Air
A series RL circuit has R of 10 and XL of 5 a its impedance in rectangular form is given by
10 +j 5
10 + j 10
10 ± j 5
10 ± j 10
What is the peak factor of a triangular wave?
An open resistor when checked with an ohmmeter reads
Zero
Infinite
High but within the tolerance
Low but not zero
The reciprocal of a complex number is
A complex number
A real number
An imaginary number
A whole number
An intermittent and non-symmetrical alternating current like that obtained from the secondary winding of an induction coil
Faradic current
Transient ac current
Inductive current
Capacitive current
The impedance in the study of electronics is represented by resistan
Inductance
Capacitance
Inductance and capacitance
Reactance
Which of the following conditions is not true for a series RLCcircuit at resonance?
Z = jXL
XL= XC
The power factor is one
The magnitude of Z is
Which of the following is a way of decreasing mutual inductance?
Moving the coils closer
Moving the coils apart
Decreasing the number of turns of either coil
Increasing the number of turns of either coil
A gang capacitor is a variable capacitor in which capacitance is varied by changing the
Dielectric
Number of plates
Plate area
Distance between plates
What theorem is generally used in the analysis of vacuum tubes?
Superposition theorem
Millman�s theorem
Thevenin�s theorem
Norton�s theorem
A capacitor consists of two
Conductors only
Dielectric only
Conductors separated by a dielectric
Dielectric separated by a conductor
In an RL series circuita
Current lags voltage by less than 90�
Current lags voltage by 180�
Current lags voltage by 90�
Current leads voltage by 90�