Home

For a small scale toy factory, the fixed cost per month is Rs. 5000/-. The variable cost per toy is Rs. 20 and sales price is Rs. 30 per toy. The break even production per month will be __________ toys.

A. 250

B. 500

C. 1000

D. 3000

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Eutectoid composition of carbon steel at room temperature is
  2. The maximum thickness of the metal which can be welded using ultrasonic welding is __________ mm.
  3. Electrochemical corrosion can occur, only if __________ is present in contact with metal.
  4. One ton of refrigeration is not equivalent to the heat removal rate of
  5. Brazing filler metal used for joining steel plates
  6. Nickel and __________ are the alloying element added in steel to increase its toughness.
  7. Though tin occurs lower than iron in the electrochemical series, yet it is coated on steel for corrosion…
  8. Venturimeter is used to measure the flow rate of fluids in pipes, when the pipe is in __________ position.
  9. The most detrimental impurity in high pressure boiler feed water is
  10. Stainless steel is welded using
  11. Routing in production, planning & control is concerned with the
  12. Yield strength of a polycrystalline metal with an average grain size d, is proportional to
  13. Yield strength of a material is determined by the __________ test.
  14. __________ is the most suitable lubricant for drawing mild steel wires?
  15. Dielectric
  16. Moist climate is the most favourable factor in the site selection far a
  17. Which of the following is prone to cup and cone fracture?
  18. For preparation of porous bearings by powder metallurgy, preferred particle shape is
  19. For a thermodynamic system undergoing a process, which of the following pairs best expresses the relationship…
  20. In electrical resistance welding, distortion results from the use of improper
  21. Cassiterite is an ore of
  22. When dry bulb temperature & wet bulb temperature of moist air is the same, it means that the
  23. Energy to be supplied to the radioactive nucleus for the emission of a neutron is __________ MeV.
  24. Which of the following is not a charge material for cupola?
  25. Out of the following, the joint produced by __________ has the lowest strength.
  26. Carbon supply in pack carburising process is in the form of
  27. Hydro-cyclone is a
  28. Gas turbine normally employs a constant __________ cycle.
  29. Titanium is added to molten aluminium alloys before casting for the purpose of
  30. __________ test is the appropriate test to determine whether a material is ductile or brittle.