Home

For generating a Coons surface we require

A. A set of grid points on the surface

B. A set of grid control points

C. Four bounding curves defining the surface

D. Two bounding curves and a set of grid control points

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. If the helix angle of the drill is made _________ 30°, then the torque required to drive the drill…
  2. Internal gear cutting operation can be performed by
  3. Ceramic tools are fixed to tool body by
  4. Small nose radius
  5. Hardness of green sand mould increases with
  6. The obtuse angle, included between the chisel edge and the lip as viewed from the end of a drill, is…
  7. The object of caulking in a riveted joint is to make the joint
  8. The operation performed on a shaper is
  9. The abrasive slurry used in ultrasonic machining contains fine particles of
  10. The specific cutting energy used for establishing the machinability of the metal depends upon its
  11. A set of eight form relieved milling cutters for each module is provided to enable cutting of gears…
  12. Flank wear occurs mainly on the
  13. In drilling Bakelite and fibrous plastics, the point angle of a drill is
  14. If the cutting speed is increased, then the built-up-edge
  15. What is the type of shielding gas for GTAW (Gas Tungsten Arc Welding) used for carbon steels only called?
  16. The lip clearance angle is the angle formed by the
  17. In a plain milling machine, the table can be moved
  18. Crater wear occurs mainly on the
  19. Work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm…
  20. What is the type of welding defect caused due to shrinkage during solidification and by weld stresses…
  21. Internal or external threads of different pitches can be produced by
  22. Threading is an operation of
  23. High speed steel drills can be operated at about _________ the speed of high carbon steel drills.
  24. The cutting speed for counter-boring should be _________ that of drilling operation.
  25. A taper tap has
  26. What is the method of brazing used to join relatively small assemblies made from materials that either…
  27. During normalizing process of steel, the specimen is heated
  28. Hard and tough materials like cast iron should be turned at
  29. The angle formed by the leading edge of the land with a plane having the axis of the drill, is called
  30. The chuck used for setting up of heavy and irregular shaped work should be