Home

Frames sent above the __________ limit will have their _________ bit set.

A. CIR, DE

B. BC, DE

C. BC, FECN

D. CIR, FECN

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. IOS images can be loaded from all the following except:
  2. The address of a Frame Relay VC is called a ___________.
  3. You are given this address space: 172.16.5.0/25. You need one network with 64 hosts and two with 30…
  4. To recall a previous command, which of the following would you use?
  5. RIP supports load balancing for up to __________ ___________ paths.
  6. You are given a Class B network with a subnet mask of 255.255.255.192. How many hostaddresses are there…
  7. VLSM allows you to summarize __________ back to the class boundary.
  8. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  9. You are given the following addressing information: 10.0.8.0/22. What type of address is this?
  10. Which VTP mode(s) will propagate VTP messages?
  11. Which command assigns a default gateway to the 2950 switch?
  12. When using debug with PAP, which of the following message types might you see?
  13. Which of the following are not features of ACLs?
  14. Which of the following situations are best for DDR connections?
  15. When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.
  16. You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
  17. What router command saves the active configuration to NVRAM?
  18. When configuring a router-on-a-stick, the configuration is done on __________.
  19. Extended traceroute works from which mode?
  20. When connecting a router to a PC, use a __________ cable.
  21. Which router command clears all of the static translations in the address translation table?
  22. Which command activates an IP ACL on a router's interface?
  23. You are given the following addressing information: 192.168.37.192/25. What type of address is this?
  24. Which of the following WAN categories does ISDN fall under?
  25. The 1900 switch supports ________ VLANs.
  26. Which control sequence moves the cursor to the end of the line?
  27. Which router command specifies the ISDN switch the router is connected to?
  28. The dialer map command contains all of the following parameters except __________.
  29. When examining the IP routing table, an EIGRP route will be shown as what letter?
  30. ___________ defines LAPD, which is responsible for the data-link layer connection between the router…