Home

What is the correct answer?

4

Francis turbine is best suited for

A. Medium head application from 24 to 180 m

B. Low head installation up to 30 m

C. High head installation above 180 m

D. All types of heads

Correct Answer :

A. Medium head application from 24 to 180 m


Related Questions

A hydraulic coupling belongs to the category of Runaway speed of a hydraulic turbine is A hydraulic accumulator is a device used to store ________ energy which… Which of the following pump is preferred for flood control and irrigation… In an outward flow reaction turbine The working of which of the following hydraulic units is based on Pascal's… In a centrifugal pump, the liquid enters the pump The hydraulic efficiency of an impulse turbine is the The specific speed of a hydraulic turbine depends upon The jet ratio is defined as the ratio of the The specific speed of turbine is defined as the speed of a unit A hydraulic intensifier normally consists of In reaction turbine, draft tube is used The angle of taper on draft tube is The specific speed of a centrifugal pump, delivering 750 litres of water… Discharge of a centrifugal pump is (where N = Speed of the pump impeller) According to fan laws, at constant speed and capacity, the pressure and… Which of the following pump is successfully used for lifting water to… The mechanical efficiency of an impulse turbine is The centrifugal pump preferred for a specific speed between 80 to 160… A jet of water is striking at the centre of a curved vane moving with… Power required to drive a centrifugal pump is directly proportional to… Pressure intensifier increases the pressure in proportion to The discharge through a reaction turbine ________ with the increase in… Which of the following turbine is preferred for 0 to 25 m head of water? The flow rate in gear pump The unit discharge through the turbine is In a reaction turbine, the draft tube is used The depth of the bucket for a Pelton wheel is generally ________ the diameter… An impulse turbine is used for