Home
Earn $100 Online Daily. Work From Home. Click Here

What is the correct answer?

4

___________ has both physical and logical ring topologies.

A. Ethernet

B. FDDI

C. Token Ring

Related Questions

Which of the following are classless protocols? What command creates a DHCP address pool on a router? Which interface type is used to connect to the serial interface of a router? Which Frame Relay command is used to manually resolve addresses? A routing protocol that supports route summarization must perform all… RIP supports load balancing for up to __________ ___________ paths. You are given the following addressing information: 192.168.37.192/25.… To recall a previous command, which of the following would you use? A ___________ is basically all of the components, hardware and software,… Which command assigns a default gateway to the 2950 switch? A _________ is a network that provides a secure connection from a company… When configuring the ip nat inside source command, which parameter must… Which frame field is different between ISO HDLC and Cisco's HDLC? You execute the line console 0 command from Configuration mode. What will… Which type of traffic is sent to a group of devices? You are at User EXEC mode and type the letter e. What message appears? Cisco routers generate LMI enquiries every _______ seconds and a full… Which of the following is true concerning bridges? Which VTP mode(s) will propagate VTP messages? _________ defines how the Frame Relay DTE and DCE interact with each other. When choosing a dynamic routing protocol, which of the following should… Which of the following are not features of ACLs? What must you do to enable IP routing on your router? (Choose all of the… Which of the following is a private address? OSPF hellos are sent every __________ seconds on a multi-access medium. The address of a Frame Relay VC is called a ___________. RIP has a maximum hop count of ____________ hops. When configuring your terminal emulation software for a console connection,… Which router command would you use to test only layer-3 connectivity? Which of the following trunking methods is/are proprietary to Cisco?