Related Questions
What is the correct answer?
4
Unit of viscosity in CGS system is
What is the correct answer?
4
If Reynolds number is greater than 1, then the
A. Viscous force is larger than the inertia force
B. Inertia force is larger than the viscous force
C. Inertia force is larger than the surface tension force
D. Inertia force is larger than the gravitational force
What is the correct answer?
4
Transition from laminar to turbulent zone in free convection heat transfer is governed by the critical value of
B. Grashoff number & Reynolds number
D. Grashoff number & Prandtl number
What is the correct answer?
4
The following type of bonding is strongly directional in solids.
What is the correct answer?
4
Energy of the sun arises mainly from __________ reactions.
What is the correct answer?
4
__________ of air does not increase with increase in temperature.
What is the correct answer?
4
Most of the phosphorous present in the blast furnace burden enters into
What is the correct answer?
4
The stress at which extension of the material takes place more rapidly as compared to the increase in load is termed as the __________ point of the material.
What is the correct answer?
4
Nuclear fission of one atom of uranium-235 produces the energy equivalent to about __________ MeV.
What is the correct answer?
4
Atomic __________ of an element is a whole number.
What is the correct answer?
4
__________ iron is produced by the annealing of white cast iron.
What is the correct answer?
4
The heat released by cooling one mole of copper from 400 K to room temperature (300 K) is (assume : Cp of copper is 23 J K-1mole-1)
What is the correct answer?
4
Powder metallurgy process does not make metal powder by
D. Electrolytic deposition
What is the correct answer?
4
Which of the following mainly decides the current to be employed is arc welding?
C. Voltage across the arc
What is the correct answer?
4
What is the percentage of chromium in 18-4-1 high speed steel?
What is the correct answer?
4
Spherical shape of mercury droplets is due to its
What is the correct answer?
4
Eutectoid composition of carbon steel at room temperature is
What is the correct answer?
4
The best lubricants for a machine working at high temperature & load is
What is the correct answer?
4
Steel balls are manufactured by
What is the correct answer?
4
__________ is the process used for setting up compressive stresses in the surface of a metal to improve its fatigue strength.
What is the correct answer?
4
Dryness factor of steam is defined as the ratio of the mass of vapor in the mixture to the mass of the mixture. Dryness factor of steam is measured by a __________ calorimeter.
What is the correct answer?
4
The most important consideration in value engineering is the
What is the correct answer?
4
Glycerine is used as a coolant in cooling of some engines instead of water, because
A. Its higher boiling point (290°C) increases its heat carrying capacity
B. Comparatively less weight of coolant is required
C. Smaller radiator can be used
What is the correct answer?
4
The excess air required for the combustion of pulverised coal is of the order of about __________ percent.
What is the correct answer?
4
Ceramic compounds as compared to metallic compounds
B. Resist greater tensile stress at room temperature
C. Have higher melting temperature
D. Are better conductor of electricity at higher temperature
What is the correct answer?
4
The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.
What is the correct answer?
4
Use of water as a manometric liquid suffers from the disadvantage of its
What is the correct answer?
4
Venturimeter is used to measure the flow rate of fluids in pipes, when the pipe is in __________ position.
What is the correct answer?
4
Steam condenser tubes are made of admiralty brass, in which percentage of zinc & copper are __________ respectively.
What is the correct answer?
4
The most abundant metal present in the earth's crust is;