Home

Identify the correct statement with reference to the extractive metallurgy of aluminium.

A. The electrolyte consists of molten Na3AlF6 with approximately 1 to 8% Al2O3

B. Approximately 80% of the aluminium deposited on the cathode comes from cryolite

C. Sodium is deposited along with aluminium, but is immediately vaporised

D. Anode effect sets in when the cryolite concentration goes below 40%.

Related Questions

  1. A steam pipe is intended to be insulated with two layers of insulating materials of different thermal…
  2. A thin, flat & square plate measuring 2 m × 2 m is freely hanging in ambient air at 25°C.…
  3. Spark plug is provided in a/an
  4. Which of the following is not an explosive?
  5. Energy of the sun arises mainly from __________ reactions.
  6. Heat required to raise the temperature of a body by 1 °C is called its
  7. The malleability of a material is the property by virtue of which it can be rolled or hammered into…
  8. Which of the following is the correct nature of shear stress distribution along the cross section in…
  9. Nitriding of a steel part does not increase its
  10. Suitability of steel for its use in cable is judged by its strength in
  11. The escape velocity of a body on earth which is independent of its mass is about __________ km/second.
  12. Which of the following is a boiler accessory i.e., not a boiler mounting?
  13. A cylindrical rod subjected to a tensile strain within the elastic limit undergoes a volume change.…
  14. Pick out the correct statement about the condensation.
  15. Regeneration of molecular sieve requires it to be heated to a temperature of about __________ °C.
  16. Non-ferrous alloys used for making cutting tools need not have high
  17. Sand used to stop the green sand from sticking to the pattern is termed as the __________ sand.
  18. Sacrificial anode method is used in the protection of pipelines which are buried underground. Sacrificial…
  19. Tesla metre per ampere (T. m/A) is the unit for the measurement of
  20. Blasting of tri-nitro-toluene (TNT) is done by mixing it with ammonium
  21. Fatigue limit improvement by over stressing the metal by successively increasing the load is called…
  22. Catalyst used in the 'catalytic converter' employed in automobile exhaust line for complete combustion/oxidation…
  23. Metallic surveying tapes are made of __________ which has a low co-efficient of expansion & enough strength.
  24. The ratio of the shear stress to the principal stress on a principal plane is
  25. Most of the phosphorous present in the blast furnace burden enters into
  26. A solution which resists change in its pH value on addition of acid/alkali is called the __________…
  27. Tumbling is the process of improving the __________ of the materials/parts.
  28. A material being tested for endurance strength is subjected to the __________ load.
  29. A psychrometer does not measure the __________ temperature of moist air.
  30. Specific __________ is a dimensionless quantity.

Please do not use chat terms. Example: avoid using "grt" instead of "great".