If a plane is parallel to the plane of projection, it appears:
True size
As a line or edge
Foreshortened
As an oblique surface
Also checkout these categories
Circulatory System MCQ Phylum - Amphibia MCQ Current Affairs July 2017 MCQ Human reproductive system MCQ Engineering Materials MCQ True Discount MCQ Networking MCQ State of Matter MCQ General Biology Set 2 MCQ Phylum - Annelida MCQ Thermo Electricity MCQ Solids, Liquides, Gases MCQ
- To insure that everyone understands what the electrical symbols represent it is customary to include…
- The standard number of threads per inch for various diameters is the:
- Referring to the fractional inches to decimal inches to millimetre conversion chart on page 55 what…
- When dimensioning architectural drawings architects will utilize both ________ and ________ options.
- Drawings created with commercial software are typically saved as:
- Traditional drafters need to be able to create several different line widths because ________.
- Architectural dimensioning is usually done in ________.
- When drawing a line using the relative coordinate system a line is created from ________.
- These breaks are used to shorten the view of an object:
- This is a rounded exterior blend between surfaces:
- Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical…
- When creating your own blocks it is important to avoid drawing any portion of the block in the ________…
- An advantage of this type of view is that each view shows the object all the way through as if it were…
- This practice considers an individual part's dimensions and tolerances and that part's relation to its…
- Oblique drawings are dimensioned in a similar fashion as these types of drawings:
- Some common blocks used by architectural drafters include ________.
- When the drafter types the word BLOCK or selects the Make Block tool from the Draw tool bar the ________…
- Oblique sections are useful to show this:
- In this type of section, one quarter of the object is removed:
- The bounding box method for setting up an isometric drawing helps the drafter ________.
- The thread note for a typical bolt will include the ________.
- PDM is the acronym for:
- The foundation contractor will work with the following architectural plans.
- The condition of a part when it contains the least amount of material is referred to as ________.
- This material is used in masonry construction, most commonly for ornamental facing:
- This is the term for the range of tightness or looseness resulting from the allowances and tolerances…
- This is a common method for connecting steel members of buildings and bridges:
- This is the theoretically exact size from which limits of size are determined:
- This is the total amount that the feature on the actual part is allowed to vary from what is specified…
- These types of pipes are generally connected with bell and spigot joints or flanged joints: