If heat contents of CH4, C2H4 and C3H8 are -17.9, 12.5 and -24.8 kcal/mole respectively, than ΔH for the reaction CH4(g) + C2H4(g) C3H8(g) will be __________ Kcal.
-19.4
-30.2
55.2
-55.2
Correct Answer :
A. -19.4
Related Questions
The entropy change in a reversible isothermal process, when an ideal gas expands to four times its initial volume is
R loge 4
R log10 4
Cv log10 4
Cv loge 4
Requisites of a reversible process is that the
System and surroundings pressure be equal
Friction in the system should be absent
System and surroundings temperature be equal
None of these
Which of the following is an extensive property of a system?
Heat capacity
Molal heat capacity
Pressure
Concentration
Throttling (Joule-Thomson effect) process is a constant __________ process.
Enthalpy
Entropy
Pressure
None of these
Pick out the wrong statement.
Minimum number of degree of freedom of a system is zero
Degree of freedom of a system containing a gaseous mixture of helium, carbon dioxide and hydrogen is 4
For a two phase system in equilibrium made up of four non-reacting chemical species, the number of degrees of freedom is 4
Enthalpy and internal energy change is zero during phase change processes like melting, vaporisation and sublimation
All gases during throttling process at atmospheric temperature and pressure show a cooling effect except
CO2
H2
O2
N2
For an ideal gas, the enthalpy
Increases with rise in pressure
Decreases with rise in pressure
Is independent of pressure
Is a path function
At equilibrium condition, the chemical potential of a material in different phases in contact with each other is equal. The chemical potential for a real gas (μ) is given by (where, μ = standard chemical potential at unit fugacity (f° = 1 atm.) and the gas behaves ideally.)
μ° + RT ln f
μ°+ R ln f
μ° + T ln f
μ° + R/T ln f
Which of the following is not correct for a reversible adiabatic process?
TVγ-1 = constant
p1-γ.TY = constant
PVγ = constant
None of these
A cylinder contains 640 gm of liquid oxygen. The volume occupied (in litres) by the oxygen, when it is released and brought to standard conditions (0°C, 760 mm Hg) will be __________ litres.
448
224
22.4
Data insufficient; can't be computed
In an ideal gas mixture, fugacity of a species is equal to its
Vapor pressure
Partial pressure
Chemical potential
None of these
A liquid under pressure greater than its vapour pressure for the temperature involved is called a __________ liquid.
Sub-cooled
Saturated
Non-solidifiable
None of these
A two stage compressor is used to compress an ideal gas. The gas is cooled to the initial temperature after each stage. The intermediate pressure for the minimum total work requirement should be equal to the __________ mean of P1 and P2. (where, P1 and P2 are initial and final pressures respectively)
Logarithmic
Arithmetic
Geometric
Harmonic
Gibbs free energy per mole for a pure substance is equal to the
Latent heat of vaporisation
Chemical potential
Molal boiling point
Heat capacity
A thermodynamic system is taken from state A to B along ACB and is brought back to A along BDA as shown below in the P-V diagram. The net work done during the complete cycle is given by the area covered by
P1ACBP2P1
ACBB1A1A
ACBDA
ADBB1A1A
The work done in isothermal compression compared to that in adiabatic compression will be
Less
More
Same
More or less depending upon the extent of work done
When a gas is subjected to adiabatic expansion, it gets cooled due to
Decrease in velocity
Decrease in temperature
Decrease in kinetic energy
Energy spent in doing work
The acentric factor of a materical, 'ω', is defined as ω = -log10(Prsat)Tr-1 = 0.7, where, Prsat = reduced vapor pressure, Tr = reduced temperature. The value of acentric factor is always
> 2
< 1
> 1
< 3
As pressure approaches zero, the ratio of fugacity to pressure (f/P) for a gas approaches
Zero
Unity
Infinity
An indeterminate value
Entropy change in case of reversible adiabatic process is
Minimum
Zero
Maximum
Indeterminate
Which of the following is not a unit of the equilibrium constant Kp? (where, Δx = number of moles of products number of moles of reactants)
(atm)Δx, when Δx is negative
(atm)Δx, when Δx is positive
Dimensionless, when Δx = 0
(atm)Δx2, when Δx > 0
What is the ratio of adiabatic compressibility to isothermal compressibility?
1
< 1
> 1
>> 1
A refrigeration cycle is a reversed heat engine. Which of the following has the maximum value of the co-efficient of performance (COP) for a given refrigeration effect?
Vapor compression cycle using expansion valve
Air refrigeration cycle
Vapor compression cycle using expansion engine
Carnot refrigeration cycle
Chemical engineering thermodynamics is concerned with the __________ in/of chemical processes.
Reaction mechanism
Calculation of rates
Energy transformation from one form to another
None of these
The value of Cp & Cv respectively for monatomic gases in Kcal/kg Mole.°K are
5 & 3
3.987 & 1.987
1.987 & 0.66
0.66 & 1.987
A solid is transformed into vapour without going to the liquid phase at
Triple point
Boiling point
Below triple point
Always
To obtain integrated form of Clausius-Clapeyron equation, ln (P2/P1) = (ΔHV/R) (1/T1 - 1/T2) from the exact Clapeyron equation, it is assumed that the
Volume of the liquid phase is negligible compared to that of vapour phase
Vapour phase behaves as an ideal gas
Heat of vaporisation is independent of temperature
All (A), (B) & (C)
At a given temperature, the volume of a gas dissolved in a solvent __________ with increase in pressure.
Increases
Decreases
Remains unchanged
May increase or decrease; depends on the gas
Change of heat content when one mole of compound is burnt in oxygen at constant pressure is called the
Calorific value
Heat of reaction
Heat of combustion
Heat of formation
Ideal gas law is applicable at
Low T, low P
High T, high P
Low T, high P
High T, low P