Home

If Th is the torque resisting capacity of a hollow shaft and Ts is that of a solid shaft, of the same material, length and weight. Then,

A. Th > Ts

B. Th < Ts

C. Th = Ts

D. None of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The torsional rigidity of a shaft is expressed by the
  2. Which of the following process can be made reversible with the help of a regenerator?
  3. Which of the following statement is correct?
  4. When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear…
  5. Which of the following gas is mostly used in town for street and domestic lighting and heating?
  6. The ratio of specific heat at constant pressure (cp) and specific heat at constant volume (cv) is always…
  7. The ideal efficiency of a Brayton cycle without regeneration, with increase in pressure ratio will
  8. Select the correct statement as per Charles' law
  9. The total strain energy stored in a body is termed a
  10. The calorific value of gaseous fuel is expressed in
  11. The variables which control the physical properties of a perfect gas are
  12. The radius of the Mohrs circle in the given figure is equal to
  13. The ratio of direct stress to volumetric strain in case of a body subjected to three mutually perpendicular…
  14. In a uniform bar, supported at one end in position, the maximum stress under self weight of bar shall…
  15. The main cause for the irreversibility is
  16. The bending moment at a point on a beam is the algebraic ________ of all the moments on either side…
  17. The pressure exerted by an ideal gas is ________ of the kinetic energy of all the molecules contained…
  18. The relation between equivalent length (L) and actual length (l) of a column for both ends fixed is
  19. The unit of energy is S. I. units is
  20. If the radius of wire stretched by a load is doubled, then its Youngs modulus will be
  21. The cycle in which heat is supplied at constant volume and rejected at constant pressure is known as
  22. The buckling load for a given material depends on
  23. The general gas energy equation is (where Q1 - 2 = Heat supplied, dU = Change in internal energy, and…
  24. If both Stirling and Carnot cycles operate within the same temperature limits, then efficiency of Stirling…
  25. A simply supported beam with a gradually varying load from zero at B and w per unit length at A is shown…
  26. The ideal efficiency of a Brayton cycle with regeneration, with increase in pressure ratio will
  27. Slenderness of a column is zero when
  28. The efficiency of Diesel cycle with decrease in cut-off
  29. The ratio of elongation in a prismatic bar due to its own weight (W) as compared to another similar…
  30. According to Avogadro's law