Home

If the tearing efficiency of a riveted joint is 50%, then ratio of rivet hole diameter to the pitch of rivets is

A. 0.20

B. 0.30

C. 0.50

D. 0.60

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The angle between the shear plane and __________ is called shear angle.
  2. The cutting speed of a drill depends upon the
  3. In determining the various forces on the chip, Merchant assumed that the
  4. Continuous chips with built up edge are formed during machining of
  5. The hole to be drilled for tapping is _________ the outside diameter of the thread on the tap.
  6. Chemical milling operation is performed
  7. The process of changing the shape of grinding wheel as it becomes worn due to breaking away of the abrasive…
  8. The size of abrasive grain required in a grinding wheel depends upon the
  9. The factor considered for evaluation of machinability is
  10. The angle between the lathe centres is
  11. When the tool moves parallel to the lathe axis, the movement is termed as
  12. Fixtures are used
  13. During the execution of a CNC part program block NO20 GO2 X45.0 Y25.0 R5.0 ; the type of tool motion…
  14. For machining a mild steel workpiece using carbide tool, the maximum material will be removed at a temperature…
  15. Small nose radius
  16. In a shaper, the metal is removed during
  17. Soft materials can not be economically ground due to
  18. Stellite preserves hardness upto a temperature of
  19. Cutting fluids are used to
  20. A twist drill is a
  21. The cutting speed is maximum while machining __________ with a high speed steel tool.
  22. The operation of smoothing and squaring the surface around a hole is known as
  23. A broach has
  24. In which of the following machine, the work rotates and the tool is stationary?
  25. Volume of a cube of side l and volume of a sphere of radius r are equal. Both the cube and the sphere…
  26. The ratio between two consecutive spindle speeds for a six-speed drilling machine using drills of diameter…
  27. In order to achieve a specific surface finish in single point turning, the most important factor to…
  28. A lathe with four steps on the cone pulley and with back-gears will have
  29. A feed gear box for a screw cutting lathe is designed on the basis of
  30. In centreless grinding, work place centre will be