In a circuita an active element is one which
Supplies energy
Receives energy
Both supplies and receives energy
Amplifies signal
Correct Answer :
A. Supplies energy
Related Questions
The hot resistance of an incandescent lamp is about ___ times its cold resistance.
For multi-plate capacitora capacitance is proportional to
Number of plates less one(n ± 1)
Number of plates plus one(n + 1)
Number of plates less two(n - 2)
Number of plates (n)
If the capacitance of mica capacitor is 5 times the capacitcitora then the relative permittivity of mica is
The electric field strength between capacitor plates has a unit
Volts per meter
Volts per mil
Amperes per meter
Amperes per mil
Liquids that are good conductors because of ionization are called
Electrolytic
Bases
Acid
Electrolytes
The second strip of an electronic resistor color-code represents
The multiplier
The second digit of the value
The temperature
The tolerance
A law which states that when a constant electromotive force is applied to a circuit consisting of a resistor and capacitor connected in seriesa the time taken for the potential on the plates of the capacitor to rise to any given fraction of its final value depends only on the product of capacitance and resistance.
Child�s law
CR law
Coulomb�s law
Debye T3 law
Why are inductance and capacitance not relevant in a dc circuit?
Because it is a simple circuit
Because dc circuits require only resistance as load
Because they do not exist in a dc circuit
Because frequency of dc is zero
Property of an electric circuit that dissipates electric energy
Reactance
Impedance
Resistance
Conductance
What theorem is usually used in the analysis of transistor circuit?
Superposition theorem
Millman�s theorem
Thevenin�s theorem
Norton�s theorem
Which of the following materials has the lowest dielectric strength?
Glass
Paper
Mica
Teflon
A trigger circuit consisting of a capacitor of 0.01 F is connected in series with a resistor. If the circuit requires 100 Vdcto operatea determine the value of the resistor when time constant is 0.009s.
900 k
900 M
900 G
The power factor of a certain circuit in which the voltage lags behind the current is 80 %. To increase the power to 100 %a it is necessary to add ___ to the circuit.
Inductance
Capacitance
Resistance
Impedance
If three 9 mH inductors are connected in parallel without mutual inductance then the total i nductance is
3 mH
9 mH
27mH
18 mH
A 5 F capacitor charge to 5V has a stored charge equal to
1 c
5 c
25 C
200 c
What refers to such work at very low temperaturesa near absolute zero?
Cryogenics
Superconductivity
Subsonic
Thermionic
A real current source has
Infinite internal resistance
Zero internal resistance
Large internal resistance
Small internal resistance
Which of the following is not considered a physical factor affecting resistance?
Length
Material type
Temperature
Cross-sectional
What is the reciprocal of capacitance?
Reluctance
Susceptance
Elastance
Conductance
What is the cross-sectional are of a conductor whose diameter is 0.001 inch?
One micron
One angstrom
One steradian
One circular mil
Tungsten filament of bulbs has a hot resistance higher than its cold resistance due to its temperature coefficient which is
Positive
Negative
Zero
Infinite
When two unequal values of resistors are connected in parallel across a dc sourcea greater current flows through the
Higher resistance
Lower resistance
Higher wattage resistance
Lower wattage resistance
Which of the following is neither a basic physical law nor deliverable from one?
Ohm�s law
Coulomb�s law
Kirchhoff�s first law
Kirchhoff�s second law
What is the total resistance of a two equal valued resistors in series?
The difference of both
The product of both
Twice as one
The sum of their reciprocals
Which of the following is a preferred resistor value?
43a000
54a321
Which of the following elements is active?
Resistor
Inductor
Capacitor
Ideal voltage source
What is the rms value of a square wave?
Equals its peak value
Equals its peak-to-peak value
Peak divided by square root of two
Peak divided by pi
What is the other name of relative permittivity?
Dielectric strength
Potential gradient
Breakdown voltage
Specific inductance capacity
If two resistances of 9 and 6 are connected in parallela the total resistance is
Refers to the outward-curving distortion of the lines of force near the edges of two parallel metal plates that form a capacitor.
Skin effect
Night effect
Edge effect
Hall effect