Home

In a differential band brake as shown in the below figure, if the length OB is greater than OA, then the force P at C should act in the downward direction.

A. Yes

B. No

C. Unpredictable

D. None of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected…
  2. In a vibrating system, if the actual damping coefficient is 40 N/m/s and critical damping coefficient…
  3. With usual notations for different parameters involved, the maximum fluctuations of energy for a flywheel…
  4. When the elements of a pair are kept in contact by the action of external forces, the pair is said to…
  5. A higher pair has__________.
  6. Relationship between the number of links (L) and number of pairs (P) is
  7. Idler pulley is used
  8. A rotor which is balanced statically but not dynamically is supported on two bearings L apart and at…
  9. When a rigid body is suspended vertically and it oscillates with a small amplitude under the action…
  10. A rotor supported at A and B carries two masses as shown in the below figure. The rotor is
  11. In a Hartnell governor, the compression of the spring is __________ the lift of the sleeve.
  12. A kinematic chain is known as a mechanism when
  13. The lower pair is a
  14. A Hartnell governor is a
  15. The fundamental equation for correct steering is (where φ and α = Angle through which the…
  16. In a four bar chain or quadric cycle chain
  17. At the nodal point in a shaft, the amplitude for torsional vibration will be
  18. When the relation between the controlling force (Fc) and radius of rotation (r) for a spring controlled…
  19. In a locomotive, the resultant unbalanced force due to the two cylinders along the line of stroke, is…
  20. The frictional torque transmitted in a truncated conical pivot bearing, considering uniform pressure,…
  21. The distance by which the __________ of the D-slide valve overlaps the steam port is called exhaust…
  22. The centre distance between two meshing involute gears is equal to
  23. The frictional torque transmitted in a flat pivot bearing, assuming uniform wear, is (Where μ =…
  24. In elliptical trammels
  25. Critical damping is a function of
  26. The advantage of the piston valve over the slide valve is that in the former case
  27. The frictional torque transmitted in a flat pivot bearing, considering uniform pressure, is (where μ…
  28. Which of the following disciplines provides study of relative motion between the parts of a machine?
  29. A watt's governor can work satisfactorily at speeds from
  30. In order to give the primary balance of the reciprocating parts of a multi-cylinder inline engines,