Home

In a good rimming steel

A. Carbon and silicon should be low

B. Silicon should be low but carbon should be high

C. Both silicon & carbon should be high

D. Silicon should be high but carbon should be low

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Chlorine acts as a bleaching agent only in the presence of
  2. The cooling rate required to freeze 1 ton of water at 0°C into ice at 0°C in 24 hours is __________…
  3. Which of the following is the most wear resistant grade of carbide used for the cutting tools?
  4. Drossing is a __________ operation.
  5. A thin, flat & square plate measuring 2 m × 2 m is freely hanging in ambient air at 25°C.…
  6. Milk is fat dispersed in water. It is an example of
  7. Flue gases pass through the following boiler accessories in a high pressure natural circulation boiler.A.…
  8. As the fluid flow rate increases, the float of the Rotameter
  9. The surface tension of a liquid, at critical temperature is
  10. Velocity of a gas in sound is not proportional to (where, T = Absolute temperature of the gas. P = Absolute…
  11. Liquor poisoning generally occurs due to the presence of __________ in it.
  12. Reynolds number of a fluid flowing in a circular pipe is 10,000. What will be the Reynolds number when…
  13. Which of the following is preferred for riveting?
  14. Which of the following contributes maximum as main source of sulphur in the blast furnace charge?
  15. Direct conversion of thermal energy to electrical energy is facilitated by the
  16. Maximum permissible sulphur content in steel is __________ percent.
  17. While the bin cards are used in the effective stores management, the queuing theory is associated with…
  18. The co-ordination number in simple cubic structure is
  19. While the oxy-acetylene flame produces a temperature of 3200°C, the temperature produced by oxy-hydrogen…
  20. __________ is used for tying the steel columns to concrete foundation.
  21. Which of the following has the highest modulus of elasticity (about 7 × 106 kg/cm2)?
  22. In a counter flow heat exchanger, hot fluid enters at 170°C & leaves at 150°C, while the cold…
  23. What is the percentage of chromium in 18-4-1 high speed steel?
  24. Which of the following is used to produce draught in the locomotive boilers?
  25. The expected efficiency of a single riveted lap joint is of the order of 50%. If the thickness of the…
  26. Inertial forces are obtained, when the elastic forces are multiplied by __________ number.
  27. Wrought iron is not
  28. Load cells used for the measurement of weight has
  29. Which of the following is not the commercial name of poly-methyl-methacrylate (PMMA)?
  30. Out of the following, the joint produced by __________ has the lowest strength.