In a plain milling machine, the table can be moved

A. Longitudinally

B. Crosswise

C. Vertically

D. All of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Larger than 15° side cutting edge angle
  2. In electrochemical machining, the gap between the tool and work is kept as
  3. The grooving is an operation of
  4. The correct sequence of the following parameters in order of their maximum to minimum influence on tool…
  5. The process of removing metal by a cutter which is rotated against the direction of travel of workpiece,…
  6. Misrun is a casting defect which occurs due to
  7. In a single point tool, the angle between the surface of the flank immediately below the point and a…
  8. The tool made of cemented carbide wear out faster at
  9. Which of the following engineering materials is the most suitable candidate for hot chamber die casting?
  10. The crystal structure of austenite is
  11. The chamfering is an operation of
  12. In ECM, the material removal is due to
  13. What is the type of welding defect caused due to poor deposition of weld rod is called?
  14. When two main plates are kept in alignment butting each other and riveted with cover plate on both sides…
  15. Chip breakers are used to
  16. The tool material, for faster machining, should have
  17. In metal cutting, use of low feeds and high cutting speeds is desired when the objective is
  18. Which of the following statement is incorrect with reference of lathe cutting tools?
  19. What is the welding defect caused due to improper control and poor removal of slog between passes called?
  20. In ultrasonic machining, tool is made of
  21. Which of the following statement is correct about EDM machining?
  22. In plunge grinding
  23. A 15 mm drilling machine means that it can drill a hole
  24. In machining metals, surface roughness is due to
  25. The grinding of long, slender shafts or bars is usually done by
  26. The angle between the face and flank of the single point cutting tool is known as
  27. In a metal arc welding process, a gas metal arc welding with magnetized flux is used and can be done…
  28. A broach has
  29. The size of a lathe is specified by the
  30. Fixtures are used