In a simple screw jack, the pitch of the screw is 9 mm and length of the handle operating the screw is 45 cm. The velocity ratio of the system is
1.5
5
25
314
Correct Answer :
D. 314
Related Questions
The velocity ratio of an inclined plane of inclination θ with horizontal for lifting a load is
sin θ
cos θ
tan θ
cosec θ
A simple pendulum of length l has an energy E, when its amplitude is A. If the length of pendulum is doubled, the energy will be
E
E/2
2E
4E
Force polygon method is applicable for
Any coplanar force system
A system of parallel forces only
Concurrent coplanar force system
Non-concurrent coplanar force system
A load of 500 kg was lifted through a distance of 13 cm. by an effort of 25 kg which moved through a distance of 650 cm. The mechanical advantage of the lifting machine is
15
18
20
26
A 50 kg boy climbs up a 8 m rope in gymnasium in 10 sec. The average power developed by the boy is approximately
400 watts
500 watts
4000 watts
None of these
Lami's theorem states that
Three forces acting at a point are always in equilibrium
If three forces acting on a point can be represented in magnitude and direction by the sides of a triangle, the point will be in the state of equilibrium
Three coplanar forces acting at a point will be in equilibrium, if each force is proportional to the sine of the angle between the other two
Three coplanar forces acting at a point will be in equilibrium if each force is inversely proportional to the sine of the angle between the other two
The unit of impulse, is
kg.m/sec
kg.m/sec
kg.m/sec2
kg.m/sec
At the instantaneous center, the velocity of the moving lamina at any instant is
Zero
Maximum
Minimum
Varying
On a mass m describing a circular path of radius r, the centrifugal force
Acts tangentially to the circular path
Acts towards the centre of rotation
Acts away from the centre of rotation
Is mw2r/g kgf
For a particle moving with a simple harmonic motion, the frequency is
Directly proportional to periodic time
Inversely proportional to periodic time
Inversely proportional to its angular velocity
Directly proportional to its angular velocity
Two parallel forces 20 kg and 15 kg act. In order that the distance of the resultant from 20 kg force may be the same as that of the former resultant was from 15 kg, the 20 kg force is diminished by
5.5 kg
6.25 kg
8.75 kg
10.5 kg
One Newton is equivalent to
1 kg. wt
9.81 kg. wt
981 dyne
1/9.81 kg. wt
A body is said to move with Simple Harmonic Motion if its acceleration, is
Always directed away from the centre, the point of reference
Proportional to the square of the distance from the point of reference
Proportional to the distance from the point of reference and directed towards it
Inversely proportion to the distance from the point of reference
The resolved part of the resultant of two forces inclined at an angle θ in a given direction is
Algebraic sum of the resolved parts of the forces in the direction
Arithmetical sum of the resolved parts of the forces in the direction
Difference of the forces multiplied by cosine θ°
Sum of the forces multiplied by the tangent θ°
A ball of mass 1 kg moving with a velocity of 2 m/sec collides a stationary ball of mass 2 kg and comes to rest after impact. The velocity of the second ball after impact will be
Zero
0.5 m/sec
1.0 m/sec
2.0 m/sec
A body of weight w placed on an inclined plane is acted upon by a force P parallel to the plane which causes the body just to move up the plane. If the angle of inclination of the plane is θ and angle of friction is φ, the minimum value of P, is
w sin (φ - θ)/cos φ
w sin (θ - φ)/cos φ
w cos (θ + φ)/cos φ
w sinθ cos(θ - φ)/sin φ
A stone is thrown vertically upwards with a vertical velocity of 49 m/sec. It returns to the ground in
5 sec
8 sec
10 sec
20 sec
The member forces in a statically in determinate truss
Can be obtained by graphic statics
Cannot be obtained by graphic statics
May be obtained by graphic statics
Can be obtained by graphic statics by trial and error
In a simple harmonic motion, the position of equilibrium is always
Stable
Unstable
Neutral
None of the above
A satellite moves in its orbit around the earth due to
Gravitational force
Centripetal force
Centrifugal force
None of these
The point about which combined motion of rotation and translation of a rigid body takes place, is known as
Virtual centre
Instantaneous centre
Instantaneous axis
Point of rotation
Rate of change of angular momentum is equal to
Force
Torque
Linear momentum
Impulse
A Seconds pendulum executes
0.5 beat per second
1.0 beat per second
2.0 beats per second
2.5 beats per second
The bending moment in an arch is proportional to
Vertical ordinate of funicular polygon
Vertical ordinate of the arch
Intercept between the arch axis and the funicular polygon
None of these
One end of a light string 4 m in length is fixed to a point on a smooth wall and the other end fastened to a point on the surface of a smooth sphere of diameter 2.25 m and of weight 100 kg. The tension in the string is
17.5 kg
19.5 kg
22.5 kg
25 kg
The centre of gravity of the trapezium as shown in below figure from the side is at a distance of
(h/3) × [(b + 2a)/(b + a)]
(h/3) × [(2b + a)/(b + a)]
(h/2) × [(b + 2a)/(b + a)]
(h/2) × [(2b + a)/(b + a)]
To avoid bending action at the base of a pier,
Suspension and anchor cables are kept at the same level
Suspension and anchor cables are fixed to pier top
Suspension cable and anchor cables are attached to a saddle mounted on rollers on top of the pier
None the these
For a given velocity of a projectile, the range is maximum when the angle of projection is
30°
45°
90°
0°
The moment of inertia of the shaded portion of the area shown in below figure about the X-axis, is
229.34 cm4
329.34 cm4
429.34 cm4
529.34 cm4
The moment of inertia of a hollow circular section whose external diameter is 8 cm and internal diameter is 6 cm, about centroidal axis, is
437.5 cm4
337.5 cm4
237.5 cm4
137.5 cm4