In an assembly section, these parts should have their section lines left out or shown solid black:
Bolts
All fasteners
Thin parts
Rivets
Also checkout these categories
Machine Input Mi-set 2 MCQ Advanced Surveying MCQ Strength of Materials MCQ CorelDraw MCQ Visual Basic MCQ Rearrangement Set 11 MCQ Rearrangement Set 1 MCQ Drawing Inference MCQ Hydraulics & Fluid Machineries MCQ Genetics MCQ Periodic Classification of Elements MCQ Mycoplasma and Bacteria MCQ
- These are accurately drawn maps of cities and towns showing property lines and other features that control…
- Some of the common terms used to describe technical drawing include:
- Oblique sections are useful to show this:
- Some traditional board drafters preferred the drafting machine over the parallel straight edge because…
- There should be a visible gap between the wall and the ________ line.
- The second line of dimensions out from the plan generally includes ________.
- A civil engineer working on a bridge design would probably rely on his ________ scale for checking printed…
- This is a common method for connecting steel members of buildings and bridges:
- The most common geometric form used in gears today is this:
- This type of weld is the most common in structural steel fabrication:
- Technical drawings typically serve one of three purposes:
- In some circumstances an entire drawing can be inserted into a different drawing as a block. When this…
- The condition of a part when it contains the least amount of material is referred to as ________.
- Switches and relays should be shown in this position with no operating force or applied energy:
- An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
- Approximately this much of the cost of product development and manufacture is determined at the design…
- The thread note for a typical bolt will include the ________.
- A projection weld is a type of:
- These gears transmit power between shafts whose axes intersect at any angle:
- These types of projectors converge at a vanishing point:
- This is the term for the range of tightness or looseness resulting from the allowances and tolerances…
- A ________ is the person responsible for verifying that the drawings in a project set are free of mistakes.
- In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in…
- A line with a tapering width can be easily created by using the __________ tool.
- Architectural drawings used to construct a house are often plotted with a scale of ¼ = 1'-0.…
- Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point…
- Geometric primitives include shapes such as ________.
- In developing a multi-view drawing, the drafter can use a ________ line to help locate the top and right…
- This is the measured size of a finished part:
- Lines of an isometric drawing that are not parallel to the isometric axes are called this: